Whirlpool ARG 733/A+ Technical specifications

52
PRODUCT DESCRIPTION
A) Refrigerator compartment
(for storage of fresh food and beverages)
1. Shelves (partly height adjustable)
2. Crispers
3. Refrigerator inner door with:
(if supplied)
a. Adjustable door trays
b. Top door tray
c. Bottom door tray
4. Drawer (telescopic extraction) (if supplied)
5. Pull-out defrost water drain
6. Rating plate
B) Freezer compartment (if supplied)
(marked with the symbol for storing
fresh food, frozen food and making ice cubes)
7. Grid (not shown in the figure, if available)
8. Freezer section
9. Ice cube trays
C) Controls
CONTROLS
A. Thermostat knob
B. Light switch
D. Thermostat control reference
E. Light bulb/LED bulb

53
HOW TO OPERATE THE REFRIGERATOR
COMPARTMENT
This appliance is a refrigerator with a star freezer
compartment.
OR is a refrigerator with a star freezer compartment.
Optimal appliance performance is obtained at ambient
temperatures between +10°C and +38°C.
Switching on the appliance
Once the power plug is inserted in the mains socket, unless the
thermostat (1) is set to symbol the inside light switches on each
time the door is opened.
Once the temperature has been set – see next chapter – the
appliance is ready for use.
Adjusting the temperature
- To adjust the temperature in the compartment, turn the
thermostat control knob:
•to lower numbers 1-2/MIN for the LEAST COLD internal
temperatures;
•to 3-4/MED for a MEDIUM temperature;
•to 5-7/MAX for the COLDEST temperature.
Thermostat setting on : no operation, no light.
Note:
The ambient air temperature, frequency of door opening and the
position of the appliance can affect internal temperatures. These
factors must be taken into account when setting the thermostat.
Important
•Thermostat adjustment (1) will depend on where the
appliance is installed, ambient temperature and frequency of
door opening.
How to use the refrigerator compartment:
Position the food as illustrated in the figure:
1. Cooked food
2. Dairy products, preserves, cheese, butter
3. Fish, meat
4. Sliced cold meat
5. Fruit, vegetables, salad
6. Small jars, eggs
7. Tubes, small jars
8. Small bottles
9. Bottles
Note:
•Cover food to prevent it drying out.
•Hot food must be allowed to cool properly before being placed
in the refrigerator.
•Make sure sufficient space is left for air to circulate around the
food.
Defrosting of the refrigerator compartment is completely
automatic.

54
HOW TO OPERATE THE FREEZER
COMPARTMENT
Only for or appliances:
Appliances with the symbol can be used to
store already frozen food.
Appliances with the symbol can be used to
store food for months and also to freeze food. The
amount of fresh food (in kg) that can be frozen in 24
hours is indicated on the appliance rating plate
(see paragraph “Product description”, point 6).
Freezing food
•Set the thermostat knob (1) to 3-4.
•Arrange the food to be frozen centrally in the
freezer compartment.
•Avoid contact between already frozen food and food that
has yet to be frozen (approx. 20 mm distance).
•After 24 hours turn the thermostat knob (1) back to the
normal position.
Important:
Wrap and seal the food in:
•Aluminium foil, cling film, watertight plastic bags,
polythene containers with lids or special freezer
containers.
When purchasing frozen food products:
•Ensure that the packaging is not damaged (frozen food in
damaged packaging may have deteriorated). If the package
is swollen or has damp patches, it may not have been
stored under optimal conditions and defrosting may have
already begun.
•Transport products in a thermally insulated cool bag.
•When shopping, leave frozen food purchases until last.
•Once at home, place the frozen foods immediately in the
freezer.
•If food has defrosted even partially, do not re-freeze it.
Consume within 24 hours.
•Avoid subjecting foods to temperature variations.
Observe the "best before" date on the package.
•Always observe the storage information on the package.
Making ice cubes
•Fill the ice cube trays (9) 3/4 with water and place them at
the bottom of the freezer compartment.
•Use a spoon handle to remove ice cube trays which stick
to the compartment.
Do not use sharp or pointed instruments.

55
HOW TO DEFROST AND CLEAN THE
APPLIANCE
Before carrying out any maintenance or cleaning
operations, unplug the appliance from the mains
socket. Defrost the freezer compartment when the ice
on the walls reaches a thickness of 3 mm.
•Remove foodstuffs from the or freezer and
turn the thermostat knob to .
•The frozen food must be wrapped in sheets of newspaper
(or a cover) and kept in a cool place.
•Clean the freezer compartment using a sponge dampened
in a solution of lukewarm water and/or neutral detergent.
•Rinse and dry carefully.
•Defrosting of the refrigerator compartment is fully
automatic.
Clean the defrost water drain outlet regularly in order to
ensure that defrost water is removed correctly.
After cleaning, reconnect the appliance to the power
supply.
Do not use abrasive products.
Prolonged disuse.
•Empty the compartments.
•Disconnect the appliance from the mains power supply.
•Defrost and clean.
•Leave the doors open to prevent formation of unpleasant
odours.

53
TROUBLESHOOTING GUIDE
When you hear these noises
..your appliance is alive!!!
1. Temperature inside the compartments is not low
enough.
• Is food preventing the doors from closing properly?
• Is the thermostat setting correct?
• Are the air circulation vents blocked?
2. Temperature inside the refrigerator compartment
is too low.
• Is the thermostat setting correct?
3. The appliance is excessively noisy.
• Has the appliance been installed correctly?
• Are the pipes at the back touching or vibrating?
• It is normal to hear the noise of the refrigerant liquid in
circulation.
4. The appliance is not working?
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the double-pole switch on?
• Do the household electrical system protection devices
work correctly?
• Is the power cord damaged?
5. Water collects at the bottom of the refrigerator
compartment.
• Is the thermostat setting correct?
• Is the defrost water drain blocked?
6. The inside light is not working. yPerform the
checks for point 4, and then:
• Disconnect the appliance from the power supply, check
the light bulb and, if necessary, replace it with a new
one:
- traditional light bulb
(max 25W)
Or
- LED bulb
(with the same characteristics),
only available from the After-Sales Service
• Removing the light bulb: Unscrew the bulb
anticlockwise as shown in the figure.
y

57
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself with the
help of the “Troubleshooting guide”).
2. Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for
about an hour before switching on again.
3. If the problem persists after this course of action,
contact After-sales Service.
Specify:
•the nature of the problem,
•the model,
•the Service number (the number after the word
SERVICE on the rating plate on the inside of the
appliance),
•your full address,
•your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
INSTALLATION
Install the freezer away from heat sources.
Installation in a hot environment, direct exposure to the
sun or installation near heat sources (heaters, radiators,
cookers) will increase power consumption and should
therefore be avoided.
If this is not possible, the following minimum distances
must be respected:
30 cm from coal or paraffin stoves
3 cm from electric stoves.
•Install the appliance in a dry, well-ventilated place.
•Clean the interior (see “How to defrost and clean the
appliance”).
•Fit the accessories.
•Check the door seal is not damaged or deformed,
especially after installation or reversal of door opening.
Electrical connection
•Ensure that the voltage indicated on the appliance rating
plate corresponds to the domestic supply voltage.
•Regulations require that the appliance is earthed. The
Manufacturer declines all liabilities for injury to persons or
damage to property resulting from failure to observe these
regulations.
•If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
•Do not use extension cables, multiple sockets or adapters.

58
ELECTRICAL CONNECTION
1) For Great Britain only
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp
fused plug, to change a fuse in this type of plug use an A.S.T.A.
approved fuse to BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the
fuse cover is lost the plug must not be used until a correct
replacement is fitted.
Correct replacement are identified by the colour insert or the
colour embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical
store.
2) For the Republic of Ireland only
The information given in respect of Great Britain will frequently
apply, but a third type of plug and socket is also used, the
2-pin, side earth type.
3) Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please
contact Whirlpool Service for further instruction. Please do not
attempt to change plug yourself. This procedure needs to be
carried out by a qualified Whirlpool technician in compliance with
the manufactures instructions and current standard safety
regulations.