Whirlpool FWEB8002 Series Installation guide

Front Load Washer
Models:
FWEB8002XX
FWEB9002XX
FWEB9503BS
FWEB10502XX
FWEB10503BS
WFC80602RT-X
WFC90604RT-X
WFC105604RT-X

Choosing water tap
Above 16mm Water leaks here.
Connecting the inlet hose
How to attach the inlet hose
1. Loosen the four screws and slide the top of the inlet
hose joint (section A in the figure) onto the faucet. Then,
securely tighten the four screws provided with the inlet
hose joint by using a screwdriver to secure the top of the
joint to the faucet.
2. Remove the CAUTION label from the inlet hose joint.
3. Turn the male coupler on the joint (section B in the figure)
clockwise to attach it securely to the top of the joint (section
A in the figure).
CAUTION:
If outer diameter of faucet is larger than caliber of the Joint
Ring, loosen the four screws and remove the Joint Ring from
the inlet hose joint.
12
Specification Sheet
drain hose holder
Connecting Water Inlet Hose to the Washer
Turn the nut clockwise till the nut is tight while holding the
hose.
Turn the nut counterclockwise after turning the faucet off
if you want to detach the water inlet hose.
Connecting the Drain Hose
1. When the machine is not in use, put the drain hose at
the back of machine (figure 1).
2. When in operation, install the drain hose into drainage
duct (figure 2); you can also put end of drain hose into
sewer, leaving space between end of drain hose and sewer
elbow to avoid difficulty in draining water out of washing
machine.
3. Clean the filter in the pump periodically to keep the wash
machine working normally.
Note: Do not take off the drain hose to avoid drainage
problems.
650-1200mm
Note：It is recommended the use of the provided hose.
10A
0.03~1.0MPa
600x580x850(Door exclusive)
600x635x850((Door inclusive)
62dB
79dB
Washing capacity
Max current
Rated voltage
Rated power
Spinning capacity
Water pressure
Product dimension
(mm)
Washing noise
Spinning noise
600x544x850(Door exclusive)
600x599x850(Door inclusive)
0.03~1.0MPa
73dB
62dB
8.0/9.0/9.5kg
&220-240V/50Hz220V/60Hz
220-240V/1750W
10.5kg
10.5kg
8.0/9.0/9.5kg

Ysame
programme as
Mixed
predefined washing time
based on soiled level, from lightly soiled to heavily
soiled for everyday wash, the operation is flexible
and fast.
it

（ ）

Press “Temp” button once, for the programme default
temperature to be displayed on screen. Press “Temp” again
to switch the temperature within temperature range.
Press“Speed” button once, default speed display on screen.
Continue to press “Speed” button, speed increasing to
maximum. Press “Speed” again, minimum speed display on
screen. Continue to press “Speed” button to increase
speed continuously.
rinse times
Press“Rinse” button once, default rinse time display on
screen. Continue to press “Rinse” button, rinse time
increasing to maximum. Press “Rinse” again, nothing display
on screen, to show rinse time zero. Continue to press
“Rinse” button to increase rinse time continuously.
the wash duration
Press the button to select the option. The programme
parameter will be displayed on the screen.
2
button
STACKING KIT SHELF
By which your dryer can be fixed on top of your washing machine to save space and to facilitate loading and
unloading your dryer in the higher position.
Press the “Time Wash” button, for the programme default
time to be displayed on screen. Press “Time Wash” again to
switch the duration within duration range.