Whirlpool LA50000XP User manual

AUTOMATIC
WASHER
Design 2000
k;qE,Capacity
LA5000XP
!wave Ovens. Trash Compactors Room Air Condltloners Oehumld~llers Automatic Washers Clothes Oryers Freezers Refrlgerator~Freezer

Parts and features
LAUNDRY TEMPERATURE
LOAD INFORMATION
MODEL AND SERIAL
,NUMBER PLATE
(not shown)
-AGITATOR
BASKET
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Cops, your Model and Serial Numbers here
When youneed service or call with o ..- -_ __-~~.-- - .-
question, have this InformatIon reacdy
M,: lc Utirnt 7.1
1. Complete Model and Serial fudrn
bers (from plate under the lid necr the -~
hinge). &Jr 3 ‘.~,TL r
2. Purchase date from sales slip - ~--~~~
COW this information In these soaces C’. )h. i‘,E-’Dote
Keep’ (his book in the Laundry In’forma- ------.
tion Center with your”Loundry Gu!de Service Comoonv
sales slip and warranty
Phone Number
There IS no warranty reglstratlon :O return Profzlf-of-purchase IS oil
that IS required for in-warranty ser, rce
2

Your
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.*
l is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l is properly grounded.‘
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the ‘Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES.
YOUR RESPONSIBILITIES
SAFETY FIRST
STARTING YOUR WASHER
WHAT HAPPENS IN EACH
CYCLE
OTHER OPERATING
INSTRUCTIONS
For a Rinse and Spin
For a Drain and Spin
ForoSoak
CARING FOR YOUR &SHER
Winterizing
IF YOU NEED SERVICE OR
ASSISTANCE.
1. Before Calling for
Assistance
2. If You Need Assistance
3. If You Need Service
4. If You Have a Problem
-2
3
3
4
6
8
8
8
8
9
10
11
11
11
11
11
,c,1985 Whirlpool Corporation - SAVE THESE INSTRUCTIONS - 3

Starting your washer
1 Measure and add detergent.
2 Place sorted load in washer.
3 Start washer
Select a
1. LOAD SIZE Select WATER
2. TEMPERATURES
l Turn the knob to point at a setting 8 Match the wash water temperature
that describes the size of load you to the type of fabrics and soils being
want to wash. washed.
l The water level can be set for SMALL
(a few items).or LARGE [a full load).
See your “Laundry Guide” for details
on load sizes.
9 All rinses are cold
Recommended wash temperatures
can be found in your “Laundry Guide”.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
DO NOT
OVERLOAD WASHER.
‘Approximate
fill with load.
LARGE (17.2 gals./65.1 L)*
SMALL (9.5 gals./36.0 L)’

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows 14 minutes of agitation in
the REGULAR HEAVY Cycle. Note:
The washer will till only when
the knob points within a FILL
area.
C. Start the washer by pulling out
the Control Knob. The washer
WIII fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle*
Each cycle has been designed for different kinds of fabrics. Numbers on the
dial in each cycle are the minutes of WASH agitation time.
When the-Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts. After agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends.
REGULAR HEAVY Cycle
A cycle for sturdily con-
strutted fabrics that are
heavily soiled.
REGULAR Cycle
A cycle for regular loads of
fabrics that are moderately
soiled.
KNITS/GENTLE Cycle
A cycle that gently washes
and spins delicate items
and washable knits.
SOAK Cycle
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of
detergent. The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.

NOTE: Ycu may hear the sound of water spraying during the
some cycles. In some cycles, cold water is sprayed on the spir
with the rinsing.
spin parts of
ining load to
Special care is needed when soaking or pre-washing laundry.
See your”Laundry Guide” for proper use of this cycle.

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and
spin for heavrly soiled loads whrch
need more detergent. [Extra de-
tergent can require an extra rinse.]
l Push Control Knob in.
l Turn clockwrse to any .on the dial
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin
Your washer can be set to drain
and spin out water
. Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle See above
drawing.
l Pull Control Knob out
l The washer will drain and spin.
For agitation and spin speeds in each cycle,see pages 6and 7
For a soak
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l Use recommended amount of
detergent or pre-soak product.
l Push Control Knob in.
9 Turn clockwise to point at a number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash?
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide!’
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.

Caring for your washer
WHEN NOT WASHING, keep both
water faucets turned off. This takes
the pressure off the water inlet Valve
and hoses.
REMOVE SHARP OBJECTS such as pins,
buckles, etc., from clothes before
washing. Close metal zippers.
AFTER WASHING, use a soft dry cloth
to wipe the outside and inside dry.
Leave the lid up until the basket is dry.
Wipe up spills right away. Spills can
dull or damage the finish.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pockets for bolts, nuts,
tools, etc.
SOME PRETREATMENT PRODUCTS
can damage washer and dryer
consoles and finishes. Do not us
these products on or near your
washer or dryer.
,di
‘e

Winterizing
Because some water stavs in the washer. freez-
ing can cause a lot of damage. If your washer is
stored or moved during the cold weather.,
1. Shut off both water 2. Put a quart of
faucets. Discon- automobile-type
nect and drain antifreeze In the
water inlet hoses. basket.
To use the washer again.. .
1. Flush water pipes and hoses.
2. Connect hoses to the washer.
3. Turn on the water faucets
3. Set the washer for a
DRAIN and SPIN
[see page 8). Let it
run for about 30
seconds to mix the
antifreeze and
water.
1
4
P
,,--
A--
++v
4. Run the washer
through a com-
plete cycle with
one cup of deter-
gent to clean out
the antifreeze.
10