Whirlpool XWT-759 User manual

XWT-759
INSTRUCTION MANUAL
Please read instructions carefully before using
Instructions for use
Preparation for use
Description of washing machine
Precautions and recommendations
Installation
Main functions
Preparation before washing
1
2
3
4
4
Guide on usage
Washing recommendations
Usage of detergent and bleach
Washing sequence
Maintenance
Clean lint filter
Clean machine
Remaining water is frozen
Trouble-shooting
5
5
6
8
8
8
8
9
Above picture for illustration purpose only. Actual product may vary.
1

Use appropriate plug. The earth
should be well connected.
Pull out the plug when not in
use.
If wiring is defective, do contact after-
sales service.
Do not install the washing machine in a damp
environment. Do not splash water on switches. Do
not put wet clothes on control panel.
Do not pour water with temperature above 50C into
the wash tub.
Do not put your hand into the spin or wash tub while

Do not dismantle, repair or refit washing machine by
yourself
Do not put hot or heavy object on the washing
machine.
Clothes stained with volatile substance(eg. Thinner,
fuel, etc) should not be washed in the washing
machine.
Do not let children play with washing machine. Keep the machine away from direct sunlight and
heat source.
Precautions and Recommendations
2
INSTALLATION
Please install your washing machine according to the instructions provided.
Using the drain hose
The hose should drain smoothly
1. The fixation height of the hose should be less than
10cm from the ground.
2. Maximum fixation height for the hanging hose(with a
hook) over a drain outlet (eg. Drain pipe, bath or
sink) should not be higher than 1.2meters above the
floor. (This is for pump drain model only)
3. Do not trample or press the hose.
Change the direction of the drain hose
Factory installation position of the drain hose is shown in
Figure 1.
The hose protrudes out of the washing tub side.
Lay down the machine. And take the hose out from the
fixing groove. (Figure 2)
Along with the grove of the washing tub side, insert the
hose with steps 1 to 3 and spread it to the washing side.
(Figure 3)
Insert the hose in the groove by hand, do not damage the
hose.
3

MAIN FUNCTIONS
1. Rinse and foam-
removing spinning
To remove excess
detergent, saving both time
and water.
Hand washing can
improve the washing ability
2. Hand washing
When filling the water into the washing tub,
please do not leave until the water level
reaches the anticipated level, then turn off
the tap
Preparation before washing
1. Install the water inlet hose. The max water pressure
permitted is between 0.5-0.6mpa
2. Be sure the earthing is in proper working condition and
insert the plug. The earthing should not join with any gas
pipe or water hose.
3. Lay down the drain hose. (Down drain)
4. Put up the drain hose (Up drain)
5. Please keep machine level, otherwise it will cause an
abnormal sound.
Attention before washing
Follow the washing instructions stated on the
clothing labels.
Remove all hard objects
(eg coins, hairpins etc.)
from clothing.
Fasten buttons and zippers.
The quantity of clothes
should not exceed the
rated capacity.
Always put clothes with
buttons in the middle of the
wash load to minimize
contact with the pulsator.
4
WASHING RECOMMENDATIONS
Total dry laundry weight should not exceed rated capacity.
The capacity will be affected by the thickness, size and type of the clothes.
If the weight of the clothing is below 2kg, do not select high water level, so as to prevent
splashing of water.
Reference weight
Work
Clothes
(1120g)
Pyjamas
(220g)
Shirt
(300g)
Undershirt
(180g)
Blanket
(900g)
Socks
(50g)
Underwear
(70g)
Jacket
(800g)
Coat
(800g)
Jeans
(800g)
Bedsheet
(600g)
USAGE OF DETERGENT AND BLEACH
How to use bleach
Fill water to the specified level, and pour the bleach into the wash tub.
Do not use bleach on coloured clothing.
Bleach should not come in direct contact with clothes.
Do refer to instructions provided by bleach manufacturer.
Powder bleach can be used, do follow instructions provided by bleach manufacturer.
Normal dissolving of washing powder
1. Fill quantity of water in the wash tub.
2. Add some washing powder, run for 30 seconds to dissolve it completely.
3. Put the clothes in and select the proper water level.
Quick dissolving of washing powder.
1. Prepare warm water of 30C in a container.
2. Put the powder in and stir.
When using powder detergent, do follow instructions provided by the detergent manufacturer.
How to use washing powder
5

WASHING SEQUENCE
Rinse (filling water)
1. Put clothes in the wash tub and select the suitable water flow according to the clothes.
2. Rinse
Adjust the wash timer to 5-7 minutes to do rinsing.
Rinse with water (Repeat the midway spinning and rinse for 2-3 times.)
1. Put clothes in the wash tub and select the suitable water flow according to the clothes.
2. Fill water to the specified level.
3. Rinse by adjusting the wash timer to 2-3 minutes. When the weight of the load is below 3kg, use
standard water flow, it may make the water splash.
Spray Rinse
1. Put the clothes into the spin tub.
2. Move the water inlet switch to spin side.
3. Select the spin time.
Notes: You may repeat the above 1-3 steps to do more than one spray rinse.
Rinsing
Spinning
1. Put the clothes in the spin tub.
2. Press the safety cover properly and close
the spin cover.
3. Spinning:
Select the spin time according to the type of
clothes.
If there is an abnormal sound produced, while
spinning, do switch off the washing machine
and re-arrange clothes.
While spinning, if spin cover is opened,
spinning will stop, just close it and it will
resume spinning.
Clothes
Spin time(m)
Bedsheet, blanket
About 4-5
Underwear(knitwear)
About 2-4
Sweater (fabric)
About 1-2
Thin clothes
About 1
Selection of spin time
To do spinning and draining or spinning(filling water) together, please first do spinning
for about 1 minute, then do draining or rinsing, otherwise the spinning will stop owing
to too much water stored in the spin tub.
7
WASHING SEQUENCE
1. Put the water inlet hose into
the inlet, move the water inlet
switch to wash the side.
2. Fill water to the
specified level and
add dissolved
washing powder.
3. Put in the clothes.
4. Select
the
program
according
to clothes.
5. Select the
wash time
according to
clothes.
6. After
washing, set
the selector
to position

Midway spinning sequence
1. Put the clothes into the spin tub.
2. Spin.
(1) Place the safety cover properly.
(2) Close the spin cover.
(3) Spin for 1-2 minutes.
3. Rinse and foam removing spin
(1) Open the spin cover
(2) Put the water inlet hose into the spin
inlet and fill water for 1 minute.
(3) Close the cover, spin for 1-2 minutes.
6

MAINTENANCE
After washing, clean lint and foreign objects from the lint filter and frame after each use.
Before cleaning, pull the plug out of the socket.
Clean the lint filter
During washing, the lint filter must
be used.
Be sure to clean it after use.
1. To remove filter, put your hand
in the groove, press and pull down
the filter.
2. Clean the filter in water.
3. After cleaning, insert the filter
into the frame, and press in the
upper part.
Clean the washing machine
Clean the machine with soft cloth.
Clean with neutral detergent.
Never wash it directly with water.
After washing, remove the water inlet hose.
Pull out the plug and hung up the wire.
Do not keep water in the wash tub for too long.
After washing, drain immediately.
Clean the outside and inside of the washing
machine with soft cloth. Leave upper cover
open and close it after 1 hour.
Hang up the drain hose as well.
When the remaining water is frozen
To prevent freezing, after each wash, drain water
completely
After complete draining, set the program/drain
selector to the strong or standard position.
If it is on the drain position, ice is hard to melt, when
it is frozen.
Pour water below 50C into wash tub to soak. Then
turn the pulsator with your hands gently until it
drains. After that, it is ready for use.
8
TROUBLESHOOTING
Problem
Reason
The machine does not work
Power failure
Machine is not plugged in or powered up.
Pulsator is clogged.
The draining hose does not work
Drain hose is not kept down.
Drain hose is frozen.
Drain hose is blocked.
Clothes outside spin tub.
Abnormal noise during washing
There are hairpins and coins or metal items
on the wash tub.
Abnormal noise and violent vibration
during spinning
Machine is not level.
Safety cover is not properly placed.
Clothes are outside spinning tub.
Amount of clothes beyond stated capacity.
Water flows from the drain hose during
first use
It is the water remained from factory
inspection of performance.
NOTE
1. Maximum allowed pressure at the water inlet : 0.6Mpa
2. Minimum allowed pressure at the water inlet : 0.3Mpa
3. The new hose-sets supplied with the appliance are to be used and that the old hose-sets
are not to be re-used.
WARNING
1. If the supply cord is damaged, it must be replace by the manufacturer or its service agent or
similarly qualified persons in order to avoid a hazard.
2. For washing machine with ventilation openings in the base, that a carpet must not obstruct
the opening.
3. This appliance is not intended for use of persons(including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
4. Children should be supervised to ensure that they do not play with the appliance.
9