Magic Flush®Product Installation Manual
WHMFL3364-EB
Before Installing:
1. Please read instructions carefully prior to installation.
2. Inspect box and its contents to verify the product is free from damage.
3. Turn off water supply drain and remove existing toilet is necessary.
4. Use an old rag to temporarily stuff in closet ange hole to block sewer gas
from entering premises.
5. Verify that the closet ange is clean and is free from any foreign substance
(paint, drywall mud, old wax ring, etc.). If necessary, use a putty knife to
clean surface of the closet ange.
NOTE: 1. We reserve the right to change the features, packing and ttings of
the product without notice.
2. Please keep the installation instructions accessible (including
installation procedure, tting form, troubleshooting, and notice).
3. Closet ange is not included.
Common Tools Needed:
• Monkey Wrench
• Pipe Wrench
• Tapeline
• Percussive Drilling
• Level
• Screw Driver
• Hacksaw
• Sinker
• Water Supply Valve
• Connecting Soft Pipe
Troubleshooting:
Pre-Cautions
1. Do not throw newspaper, diapers, sanitary napkins, or similar articles in the toilet bowl.
2. To maintain the normal ushing function of the toilet, please use a long handle nylon brush and a neutral cleanser
to clean bowl to prevent the accumulation of mineral substances. It is suggested to clean your
toilet once a week.
3. Clean the lter at least once a month to prevent slow water inletting or water blockage in the tank. Clean only
with a mild soap solution. Avoid using any cleaner that is abrasive or caustic.
4. Do not use any cleanser in the tank, otherwise the rubber accessories in the tank may be damaged, causing leakage.
5. Introducing chemicals into the tank cavity including toilet bleach or cleanser tablets will void manufacture’s warranty.
6. Do not allow the water closet to freeze while water is present in any component of the xture.
Please follow what is specied below to avoid discoloration, deformation,
ne cracks, or scratches on the toilet seat:
1. Do not expose the toilet seat to sunlight or sources of heat
2. Do not use sharp or abrasive materials to clean the toilet seat
3. Do not use corrosive chemicals to clean the toilet seat
Malfunctions Reasons Solution
1. The main water valve is not open
2. Incoming water lter net is clogged
3. Fill valve need adjustment
1. High water pressure
2. Flush Valve leaking
3. Water inlet valve is broken
1. The water level of ll valve is too low
2. The push button does not reach pushing point
3. Press the wrong button
1. The drainage outlet is not aligned with the
outside drainage pipe
2. Drainage pipes are obstructed
1. The nuts of water inlet valve are not
fastened
2. The water supply spacer of inlet valve is
damaged
1. Drainage pipe is obstructed
2. Water outlet pipes are obstructed
• No Incoming Water
• Non-Stop Incoming Water
• Inadequate Flushing Water
• Slow Drainage or
Inadequate Suction
• Leakage
• Overow From Drainage Pipe
1. Turn on the valve
2. Clean the net
3. Readjust ll valve
1. Reduce water pressure
2. Readjust ush valve
3. Call your dealer to replace
inlet valve
1. Adjust the ll valve to
appropriate position
2. Adjust water level rod
3. Identify small and large
ushing button, or call
your dealer
1. Readjust or reinstall the
product
2. Clean the drainage pipes
1. Fasten the nuts
2. Change the water supply
spacers
1. Clean the drainage pipes
2. Clean the water outlet pipes
• Silicone
• Flange
• Toilet Shims
