wildkin Slatted Step Stool User manual

Thank you for purchasing a Levels of Discovery Slatted
Step Stool! To get started, please first be sure you have all
the necessary components. We suggest that you lay them
all out on the carpet before assembling. If for any reason
you think a component may be missing, please contact our
customer service team.
Tools Needed for Assembly:
Allen wrench (included). CAUTION: It is highly recom-
mended that you not use power tools or electric
screwdrivers as screws should not be over-tightened.
General Safety Instructions:
This step stool is recommended for an individual up to
200 lbs.
Care Instructions:
Wipe clean with non-bleach cloth.
Page 1 of 2
P: 866-727-0544 E: [email protected] www.wildkin.com
Slatted Step Stool Assembly Instructions
Components
A. 1- Slatted Step B. 1- Left Side Panel
o2. 1- Allen Wrenchs7. 4- Large Screws
C. 1- Right Side Panel
ADULT ASSEMBLY REQUIRED.
SMALL PARTS AND SHARP POINTS MAY BE PRESENT PRIOR TO ASSEMBLY.
KEEP OUT OF BABY’S REACH.
PLASTIC BAGS CAN BE DANGEROUS. TO AVOID DANGER OF SUFFOCATION, KEEP THIS
BAG AWAY FROM BABIES AND CHILDREN.
WARNING:

Page 2 of 2
P: 866-727-0544 E: [email protected] www.wildkin.com
1. Align holes on Left Side Panel (B) with pegs on Slatted Step (A).
s7
s7
C
B
Peg
A
2. Insert Large Screw (s7) into holes on Left Side Panel (B) and tighten with Allen Wrench (o2) until
secure.
* Hint: If the Large Screws (s7) do not screw in properly, be sure that each nut sleeve in Slatted
Step (A) is aligned with the hole. You can check the alignment by looking through each hole on the
side of Slatted Step (A). If not aligned, use screwdriver to turn nut sleeve until it aligns.
secure.
4. Insert Large Screw (s7) into holes on Right Side Panel (C) and tighten with Allen Wrench (o2) until
3. Align holes on Right Side Panel (C) with pegs on Slatted Step (A).
Figure 1: Attach Side Panels to Slatted Step
Slatted Step Stool Assembly Instructions