Wilson Electronics WPTV28E User manual

H. Wilson Company
Phone [phone]
Fax [phone]
WPTV28E/ WPTV28CE
WPTV42E/ WPTV42CE
Mobile Plasma Mount
Parts List:
(1) Top shelf with handle & 4 bosses
(1) Bottom Shelf with caster inserts
and four bosses
(1) Electrical Assembly if 'E' model
was purchased
(2) 4” Swivel casters with brake
(2) 4” swivel casters
WPTV42C Model Additional Parts:
(4) Straight Legs/no channels
(4) Fluted Legs w/channels
(1) Middle shelf with 8 leg bosses
(1) Cabinet Pack
WPTV42E Model Additional Parts:
(8) Straight Legs/no channels
(1) Middle shelf with 8 leg bosses
WPTV28C Model Additional Parts:
(4) Fluted Legs w/channels
(1) Middle shelf with 8 leg bosses
(1) Cabinet Pack
WPTV28E Model Additional Parts:
(4) Straight Legs/no channels
(1) Middle shelf with 8 leg bosses
1. Place top shelf on rm surface, under-
side up. For WPTV28CE use uted legs
at this time. For WPTV42CE, use straight
legs at this time. Insert legs onto leg
bosses. Press t as much as possible with
hands. Tap rmly with rubber mallet if
necessary.
2. If making a WPTV28CE, your table has
no middle shelf, please proceed to step
4. Otherwise, postition middle shelf, un-
derside up, onto legs. Press t as much
as possible with hands. Using rubber
mallet, rmly seat legs into shelf.
3. FOR WPTV42CE ONLY - Place 16½" uted
legs onto leg bosses. Press t as much as
possible with hands. Seat rmly with rubber
mallet.
5. Position bottom shelf, underside
up, onto legs. Firmly seat shelf onto
legs using rubber mallet.
6. Insert casters into caster sockets,
making sure that you have the two
locking casters in the caster sockets
on the 18" long side of the cart that
has the handle.
To attach the electrical assembly, please see
the instructions included with the assembly.
***NOTE: Fluted legs should be placed over bosses with the uted channels towards each other, facing in.
Step 4: Locate back panel and slide down
into grooves of the 2 back legs (same side as
electrical bracket on top shelf. Take the two
side panels, slide into place. Take front panel
and slide into place positioned so that the
lock will be on the left.

Parts for WPSMS
(1) Base
(2) Poles
(1) Mounting Bracket for
Pedestal
(4) 3 1/4” Machine Bolts
(4) Self-locking Nuts
(4) 5/16 -18” Bolts
(4) Washers
(4) Nuts
Instructions:
1. Put base on middle shelf secure with bolts. *Please note base has been redesigned with
a rectangle base instead of the 'W' shown in photos. This does not change the assembly.
2. Place poles through the holes in the top shelf and seat in the uprights on the base.
Secure with bolts.
3. Place mounting bracket for Pedestal over pole ends at desired height. Secure with bolts.
4. Open box for WFST, Single Stud Plasma Mount, and take out the Large plate, Attach to
Pedestal Mounting Bracket, by lining up the 4 holes and securing with (4) 5/16-18” bolts,
washers and nuts.
5. Put mounting arms onto back of TV and secure with appropriate hardware (included with
WFST mount).
6. Follow instructions included with WFST mount.
Mounting Bracket
for Pedestal
1
2