Wilson Electronics WTFS91 User manual

Parts List
(3) Top Shelves - no handle (18" x 24")
(3) Middle Shelves (18" x 24")
(3) Bottom Shelves with caster sockets (18" x 24")
(6) Sets of fluted legs (4 each set)
(8) 4” Swivel Casters
(1) Electrical Assembly (if ordered)
Hardware pack
WTFS91 Flat Panel TV Stand
H. Wilson Company
2245 Delany Road
Waukegan, IL 60087
Phone: [phone]
www.hwilson.com
[email protected]
SHELF ATTACHMENT
The shelves need to be bolted together as shown
in photo.
1. Match up shelves. Bottom shelves have caster
sleeves. Line up holes and bolt together with
enclosed hardware.
Middle shelves have leg bosses on both upper and
lower parts of shelves. Center middle shelf has
predrilled holes for the TV stand base. Line up
holes and bolt together with enclosed hardware.
Top 18” x 12” shelf has 2 bosses on the underside
only. Center top shelf has predrilled holes for the
TV stand base.
2. Turn bottom shelf set to expose caster sleeves.
you have 8 casters. where the shelves are joined,
place one non locking caster on one side and one
on the other side of the join.
Tap remaining casters into place until fully seated.
CASTER
Rubber Mallet Optional: metal hammer with
block of wood to cushion impact.
Required Tools
(not included)

LEG (Onto Bottom OR Middle Shelf)
(Bottom) Turn over shelf
(shelves).
(Any) Press fit legs over bosses.
Gently tap with mallet if neces-
sary.
Insert panels in your chosen
configuration.
MIDDLE SHELF SET
Middle shelf set will have 24 bosses, 12 up & 12
down. Place the bosses on the underside (ribbed)
into the top of the lower legs. Make sure you posi-
tion the predrilled holes at the rear of the unit. Press
fit first and tap with mallet if necessary.

*** Final Step For all - Attach Electrical Assembly To
Molded Bracket As Shown In Packaged Instructions
If Ordered.
Put base on middle shelf secure with bolts.
Press fit legs over all bosses. Gently tap with mallet if necessary.
Insert panels in your chosen configuration.
Place top shelf set onto the top of the legs, lining the predrilled holes up with the base on the middle shelf.
Put inlays on top shelves.
Place poles through the holes in the top shelf and seat in the uprights on the base that is on the middle shelf. Secure with bolts.
Place mounting bracket for Pedestal over pole ends at desired height. Secure with bolts.
Open box for WFST, Single Stud Plasma Mount, and take out the Large plate, Attach to Pedestal Mounting Bracket, by
lining up the 4 holes and securing with (4) 5/16-18” bolts, washers and nuts.
Put mounting arms onto back of TV and secure with appropriate hardware (included with WFST mount).
Follow instructions included with WFST mount.