Winco VCCD Series User manual

Mobile Wire Shelving Cart
1Place the shelf onto flat ground or sturdy surface
Attach sleeve clip to the post at desired shelf height
Align the post with the self corner
Place a 3/4" thick cardboard piece onto the post
(this will help to prevent scratches)
Tap the post into place with a rubber mallet
Repeat for remaining posts
2Attach sleeve clips to the posts at desired shelf height
Align the second shelf with the posts
Use rubber mallet to tap down the shelf to desired height
3A Attach sleeve clips to the posts at desired shelf height
Align the third shelf with the posts
Use rubber mallet to tap down the shelf to desired height
3B Attach sleeve clips to the posts at desired handle height
Align the handles the posts
Use rubber mallet to tap down the handles to desired height
Attach sleeve clips to the posts at desired shelf height
Align the third shelf with the posts
Use rubber mallet to tap down the shelf to desired height
ORInstallation A Installation B
CAUTION:
DO NOT use a metal hammer
or the legs may bend

Mobile Wire Shelving Cart
4A Flip the cart upside down
Attach the casters into the holes of the posts with the rubber mallet 4B Flip the cart upside down Attach the casters into the holes of the posts with the rubber mallet
5A Flip cart right side up
Attach sleeve clips to the posts at desired handle height
Align the handles the posts
Use rubber mallet to tap down the handles
5B Flip cart right side up
ORInstallation A (cont.) Installation B (cont.)