Wind Mill Slatwall RTA CUBE User manual

RTA CUBE
ASSEMBLY INSTRUCTIONS
Using a #2 Phillips screwdriver, install the
camlock pins into the pre-drilled holes in
the (4) kick base boards. (See Figure 1)
Install camlocks into the large holes in the
kick base boards and tap into position with
the rubber mallet. (See Figure 2)
NOTE: Ensure the hole in the side of the
camlock faces outward.
Arrange the (4) kick base boards to form
a square. At each corner of the square, set
the camlock pins of one board into the cam-
locks of the adjacent board. (See Figure 3)
Connect the camlocks and pins by inserting
the screwdriver into the top hole of the cam-
lock and turning clockwise. (See Figure 4)
PRO TIP: Tilt the screwdriver at an upward angle
while twisting to better lock the camlocks.
1
2
3
4
TOOLS NEEDED
Conrmat Screw x 20
Camlock x 12Cube Panel x 4 Dowel Pin x 8 Screw Cap x 20 Kick Base Board x 4 Spinner Base Top x 1
Camlock Pin x 12 Pan Head Screw x 16 Caster x 4 Cube Top x 1
KIT COMPONENTS
KICK BASE ASSEMBLY
windmillslatwall.com Made in USA 1-800-548-7528
#2 Phillips Screwdriver Rubber Mallet
(optional)

SPINNER BASE ASSEMBLY
CASTER INSTALLALTION (OPTIONAL)
CUBE TOP INSTALLALTION
CUBE PANEL INSTALLATION
Set the spinner base top on a protected surface. Make
sure the underside of the spinner base top is facing up.
Install the camlock pins into the pre-drilled holes of the
spinner base using the screwdriver. (See Figure 1)
Set the kick base onto the spinner base, aligning the
camlocks and camlock pins, and tighten the camlocks.
(See Figure 5)
NOTE: If you do not want the spinner base to rotate, install a screw through the bottom base panel into the top base
panel, taking care not to puncture through the surface of the top base panel. This will stabilize the spinner component
of the base unit.
1
2
Position the casters onto each of the four corners of the
kick base assembly. (See Figure 6)
Using (4) pan head screws per caster, attach the casters
through the pre-drilled holes on the inside corners of
the kick base. (See Figure 6)
PRO TIP: Install all screws before the nal tightening to allow
for easier alignment of casters.
1
2
Fit the cube top onto the panels with the dowel pins
provided. (See Figure 9)
To conceal the screw heads, peel the decorative screw
cover caps to expose the sticky back, carefully center
over the screw heads, and press in place.
1
2
1
2
3
54
6
3
Flip the spinner base top so that the right side is up.
Insert (4) wooden dowel pins into the pre-drilled
holes on the base top and tap them into position
with a rubber mallet.
NOTE: Two people are recommended for steps 3
through 5.
Install (2) panels onto the dowel pins so that they
form a corner. Locate the holes on the bottom of
the panels and guide them onto the dowel pins.
(See Figure 7)
Attach the panels together by installing conrmat
screws into the pre-drilled holes using a #2 Phillips
screwdriver. (See Figure 8)
PRO TIP: Do not fully tighten the screws until all
the cube panels are in place.
Install the remaining panels in the same manner
to complete the unit.
Once the cube panels are in place, tighten all
screws completely.