Wind Mill Slatwall RTA I-UNIT User manual

RTA I-UNIT
ASSEMBLY INSTRUCTIONS
Using a #2 Phillips screwdriver, install the camlock
pins into the pre-drilled holes in the (4) kick base
boards. (See Figure 1)
Install camlocks into the large holes in the kick
base boards and tap into position with the rubber
mallet. (See Figure 2)
NOTE:
Ensure the hole in the side of the camlock
faces outward.
Arrange the (4) kick base boards to form a square.
At each corner of the square, set the camlock pins
of one board into the camlocks of the adjacent
board. (See Figure 3)
Connect the camlocks and pins by inserting the
screwdriver into the top hole of the camlock and
turning clockwise. (See Figure 4)
PRO TIP:
Tilt the screwdriver at an upward angle while
twisting to better lock the camlocks.
1
2
3
4
TOOLS NEEDED
windmillslatwall.com Made in USA 1-800-548-7528
#2 Phillips Screwdriver Rubber Mallet
(optional)
KICK BASE ASSEMBLY
Conrmat Screw x 6
Camlock x 16Center Panel x 1 Wing Panel x 2Screw Cap x 6 Kick Base Board x 4 Spinner Base Top x 1
Camlock Pin x 12 Pan Head Screw x 16 Caster x 4
KIT COMPONENTS

I-UNIT DISPLAY PANELS INSTALLATION
1
2
3
4
5
6
Flip the spinner base top so that the right side is up.
Screw (4) camlock pins into the predrilled holes on the
top of the base.
Install the (4) camlocks into the (2) wing panels using
the rubber mallet.
Attach both panel wings to the center panel by install-
ing conrmat screws into the pre-drilled holes using a
#2 Phillips screwdriver. Be sure that the camlocks are
facing the center panel. (See Figure 7)
PRO TIP:
Do not fully tighten the screws until all the panels
are in place. Once both wing panels are in place, tighten the
screws completely.
Set the center panel and wing assembly onto the base
over the camlock pins and lock the camlocks. (See
Figure 8)
To conceal the screw heads, peel the decorative screw
cover caps to expose the sticky back, carefully center
over the screw heads, and press in place.
SPINNER BASE ASSEMBLY
CASTER INSTALLALTION (OPTIONAL)
Set the spinner base top on a protected surface. Make
sure the underside of the spinner base top is facing up.
Install the camlock pins into the pre-drilled holes of the
spinner base using the screwdriver. (See Figure 1)
Set the kick base onto the spinner base, aligning the
camlocks and camlock pins, and tighten the camlocks.
(See Figure 5)
NOTE: If you do not want the spinner base to rotate, install a screw through the bottom base panel into the top base
panel, taking care not to puncture through the surface of the top base panel. This will stabilize the spinner component
of the base unit.
1
2
Position the casters onto each of the four corners of the
kick base assembly. (See Figure 6)
Using (4) pan head screws per caster, attach the casters
through the pre-drilled holes on the inside corners of
the kick base. (See Figure 6)
PRO TIP: Install all screws before the nal tightening to
allow for easier alignment of casters.
1
2
3