WIREFY WIREFY-CRMP-A5 User manual

Follow these guidelines for making secure and pristine wire crimps with Wirefycrimping tool
for heat shrink connectors. By following these easy steps, we hope you'll have a new outlook
on crimping and will avoid some common mistakes.
Website: www.wirefyshop.com
Email: [e-mail]
Phone: [phone]
WIREFY-CRMP-A5
CRIMPING TOOL
MANUAL

2
2. Insert the connector
into the tool
Once the connector is inserted into the
die nest, tighten down slightly until you
hear the first ratchet click. The terminal will
be held in place, so next you can insert
your wire.
1. Choose the right
connector size
Start off by picking the right connector size
for your wiring project. Your crimping tool
has 3 die nests that are color marked.
Insert the connector into the die nest with
a matching color.
3. Insert the wire into
the connector
Insert the stripped wire into the connector
barrel. Hold the wire with your hand to
ensure it does not slip out of the connector
until the crimp is finished.

3
4. Make the Crimp
When you have the wire properly placed,
complete the ratcheting closure of handles
until they spring open. Remove the crimped
connector carefully for further inspection.
Apply heat to finish your connection. With a
ratcheting crimp tool, the consistent
crimping results can be repeated easily
even by someone with little training.
Pro tip: Adjust
compression
If the crimp is too hard (heat shrink insulation
is damaged), or too soft (wire can be easily
pulled out of the crimp), you can adjust the
crimp height. 1.Remove set screw. 2.
Rotating the adjustment wheel
counterclockwise increases the crimp force
and decreases the crimp height. 3. Rotating
the adjustment wheel clockwise decreases
the crimp force and increases the crimp
height. 4. Reinsert set screw
5. Inspect your crimp
Inspect the crimping area to make sure
that single crimping indent was applied
right on the connector barrel. Heat shrink
insulation should remain intact after the
crimp has been completed.

4
7. Safety release
If it is necessary to open the crimping tool
prior to full closure, press the handles
together slightly. Press the emergency
unlocking quick release trigger (push it in)
and open the handles simultaneously.

5
Thank you for being our valued customer.
If you have any questions, please email us at [e-mail]