WIS NETWORKS WIS-ANS5818-90 User manual

Quick Setup Guide
WIS-ANS5818-90

Install the antenna
Attach the antenna to a pole which is less than Φ50mm.
Thread the ‘U’ screws across the mounting pole and groove and at
another side tighten with the M6 nuts.
Attach the ‘L’ type bracket to the back of the antenna, tighten with
M6 nuts.
You should install the antenna at a proper height and tilt angle to provide
target area wireless coverage.
1
1
2
3
Note

Connect the antenna to the base station, here we use WIS-S5300. With
this model, you need a pigtail to connect the N-type connector on the
antenna and the RP-SMA connector on the wireless device.
Connect to wireless base station
2
Antenna Specification
3
The connectors on the antenna is default with N-type. We can customize
them with RP-SMA connectors for better compatible with WIS-S series
base station.
Note
90
-90
120
-120
150
-150
180
60
-60
30
-30
0
ElevationAzimuthVSWR
1.2 1.4
5.0 5.5 6.0
GHz
1.6 1.8
NETWORKS
N-type Connector
Pigtail
RP-SMA Connector

Warranty Info
Model: S/N:
Purchase Date: Distributor:
Customer: Address:
Contact: Tel/Mobi:
Terms of Warranty:
You have 1 year warranty service from the date of purchasing Wisnetworks products.
In case of any below condition would not covered by warranty:
1. Damage by transportation and handling.
2. Damage by unauthorized disassembly.
3. Non-compliance of the using environment.
4. Force majeure factors like fire, earth quake, lightning, etc.
5. Human reasons without according to the guide or user manual.
6. Warranty S/N different with device S/N or obliterated