WIS NETWORKS 5G CPE Pro User manual

5G CPE Pro
Quick Start Guide

Introduction
Thank you for choosing WIS-AX3000-5G CPE Wireless Router. This Quick Start Guide is designed to
familiarize you with the use of the CPE and describes how to apply it in your family and small business.
5G CPE Pro
Accessories
Antenna x 4 Power Adapter x 1 Quick Start Guide x 1

ON/OFF P WR
WAN
1 2 3 4
Hardware Overview
Back Ports
WAN
RST
ON/OFF
PWR
LAN
RST
LTE/5GAntenna
SIM
ANT1-4
SIM
ON/OFF
PWR
LAN 1-4
WAN
Ports Description
LTE/5G Antenna
Micro-SIM Card
Power Supply DC 12V
LAN 10/100/100 0Mbps
WAN 10/100/1000/2500Mbps
Power Switch
Power on: The power indicator is on
Power off: The power indicator is off
Reset Button
Press more than 6 seconds to restore factory
RST

Front LEDs
Wi-Fi
LEDs
On: the WiFi is available
Off: the WiFi is disabled
Description
0LED: No Signal
1LED: Weak
2LED: Middel
3LED: Good
4LED: Excellent
5G/LTE Signal
Wi-Fi
5G/LTE Signal

Hardware Installation
Inserting Micro-SIM Card
Insert a micro SIM card into the SIM card slot at the top of the CPE.
NOTE:
1. Insert the SIM card in the direction indicated by the silk screen, with the notch facing in.
2. Do not insert or remove the SIM card when the CPE is powered on.
SIM
ON/OFF P WR
WAN
RST
1 2 3 4
ANT1 AN T2 ANT3 ANT4
SIM
RST

ON/OFF PWR
WAN
1 2 3 4
RST
NOTE: Observe the status of each LED to judge whether the device starts normally.
Use the power adapter to connect the power port of the CPE to the local power source.
Connecting to the Network Device
1. Connection through Wireless Network
NOTE:
Internet access device can be connected to CPE through wireless network.
Default WLAN wireless network name (SSID) Wi-Fi 2.4G and Wi-Fi 5G.
Connecting to the Local Power Supply

ON/OFF PWR
WAN
1 2 3 4
RST
2. Connection through an Ethernet Cable
Internet access device can be connected to any LAN port of the CPE through an Ethernet cable.
NOTE: ease consult the broadband operator for specific Internet parameters.
Conguring the 5G CPE
Conguring the 5G CPE Using the Web-based Interface
Step 1: Connect your Internet access device to any LAN port of the CPE.
Step 2: Open a web browser window, enter the IP address (192.168.1.1) shown on the nameplate
at the bottom of the CPE to enter the web management interface. The default login
password is admin .
Step 3: Modify the default WiFi settings. You can modify the SSID and password in the Wi-Fi
configuration interface.
Step4: Set the CPE to Ethernet uplink.
(1) Connect the WAN interface of the device to the broadband network port of the operator's home.
(2) Configure the Internet parameters in the WAN settings of the Web management interface.
Password
Logi n
Language English
?

Online Support
For more guide and help, please go to
www.wisnetworks.com
You can contact email
[e-mail]
We’ll reply you within one weekday.