CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
2 Bracket, mounting (stainless trim only)
10 Screw, #8-18 x 3/8"
6 Screw, #6-18 x 1"
4 Screw, #6-32 x 3/4"
2 Screw #8-15 x 1/2"
3 Assembly, duct (bottom, rear, and top)
2 Trim, side
4 Tape, black foam
CONVECTION MICROWAVE - E SERIES TRIM INSTALLATION
1For black trim, proceed to step 4.
2Position the mounting brackets flush with the cabinet
face and base support.
3Pre-drill the holes then use six #6-18 x 1" screws to
attach the brackets to the cabinet frame.
4Place the microwave onto the bottom duct.
5Insert the horizontal duct into the vertical duct to create
the rear duct assembly and secure with one #8-18 x
3/8" screw.
6Remove the existing screws from the upper right and
left rear of the microwave. Do not discard.
7Position the rear duct assembly on the microwave and
secure using the screws removed in the previous step.
8Position the three remaining duct sections on top of the
microwave to create the top duct assembly.
9Secure each section with two #8-18 x 3/8" screws (one
per side) and insert one #8-18 x 3/8" screw in the top
section.
Convection Microwave - E Series Trim Installation
wolfappliance.com 800.222.7820
9020747 REV-A 04/2018 Page 1 of 2 *9020747$REVA*
