wolfappliance.com | 39
MICROWAVE OVENS
Planning Information
DROP-DOWN DOOR MICROWAVE
The drop-down door microwave oven can be installed in a
standard or ush inset application.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For ush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Drop-Down Door Microwave 57 kg
TRIM OVERLAP 60 cm MODEL 76 cm MODEL
Top 5 mm 5 mm
Bottom 0 mm 0 mm
Sides 18 mm 98 mm
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations on
the following pages. The receptacle may also be located
in an adjacent cabinet within reach of the power cord. A
separate circuit servicing only this appliance is required. A
ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply 220-240 V AC, 50/60 Hz
Service 1600 W
Receptacle grounding-type (earthed)
Power Cord 1.2 m