6
Assembly
Install the Legs and Leg Levellers
The leg bolts have been installed in the mounting holes
in
the stove bottom at the factory. Washers and leg levellers
are located
in
the bag with this manual.
Handle
enamelled
castings
tenderly
to
avoid
chipping!
If
assistance Is available,
It
is
most
easy
to
Install
the
legs by tilting the stove forward to rest on its front. The
Front Panel of the stove must be removed before tilting the
stove. Use the following procedure.
Prepare a
padded
surface, such as a thick carpet or a
thick blanket folded two or three times, to protect the stove
and the floor while the legs are installed.
Step
1.
Remove the small retainer blocks that have been
stapled to the pallet
in
front
of
the stove. Remove any
staples from the pallet to prevent scratching the stove.
Step
2.
Disengage the
two
compression latches on the
stove bottom by pulling each latch down and forward. Fig.
1.
Step
3.
Lift
the Front Panel from the bottom and pull it
up
and forward away from the stove. Fig. 2.
Step
4.
Carefully tilt the stove forward onto the padding.
Step
5.
Remove each leg bolt from the holes
in
the
bottom and attach the legs using the bolts and washers.
Tighten the bolts firmly with a 9/16' wrench.
Use the leg levellers if the stove will
be
standing on an
uneven surface. Screw a leveller all the way into the foot of
each leg and adjust as necessary when the stove is
in
its
final position.
If
no
ass'.fance
,.
available,
the legs
can
be
installed one corner at a time
by
gradually sliding the stove
off of the shipping pallet as follows. You will need a 9/16'
socket wrench and extension. Install the leg levellers before
attaching the legs to the stove.
Step
1.
Remove the small wood blocks stapled to the
pallet in front of the stove. Be sure to remove all
01
the
staples to prevent scratching the stove.
Step
2.
Carefully pivot the stove until one front corner
overhangs the pallet enough to attach a leg to the stove.
Remove the hex head leg bolt from the stove bottom
and
use it together with a flat washer to attach the leg to the
stove. Fig. 3.
Step
3.
Slide the stove forward and swing the other front
corner off
of
the pallet enough to secure the other front leg.
Fig.
4.
Step
4.
Carefully swing the stove out over a front comer of
the pallet just enough
to
allowaccess
to
the rear corners.
Be
sure
the
stove bottom
is
adequately supported bythe pallet.
Attach both rear legs. Fig.
5.
Step
5.
Walk the stove into the final position.
Figure
2.
Figure
1.
Figure
3.
Install
second
front leg.
/
5.
Install rear leg.
