WorkPro W082053A User manual

24" WIDE ROLLING TOOL STORAGE CABINET
W082053A
PARTS INCLUDED
Locking bar x1
Top chest handle x2
M4x8 Screw x8
Swivel casters
with brake x2
Swivel casters
without brake x2
TOOLS REQUIRED
OPERATOR'S MANUAL
10.2"
13.6"
29.7"
24.4"
13.0"
23.6"
WARNING:
To reduce the risk of injury, the user must read and
understand the operator’s manual before using this
product.
The tool cabinet only for indoor use.
2 persons are necessary for assembling.
Assembled incorrect may cause damage to the
cabinet or failure resulting in personal.
All the connections have to be checked and the
screws have to be tightened in regular periods.





WARNING:
Do not open more than one loaded drawer at a time.
Do not put any tools on the door when opening. It may cause damage to the door or failure resulting in personal.


WORKPRO

If caster assembly fits loose,
using a screwdriver, slightly
spread apart split bearing on
shaft. If caster fits tight, crimp
split bearing slightly with
pliers.Make only slight
adjustments, until caster fits
properly.
1
Ensure all components are present. If any components are missing, do not proceed with assembly. Contact
Brands customer services at [email protected]
ASSEMBLY
REMOVE THE 4 SCREWS
ON BOTTOM
4HANDLE ASSEMBLY
2REMOVE SIDE PANEL
Remove screws with a
screwdriver.
Remove screws with a
screwdriver.
5CASTER ASSEMBLY
3REMOVE CHEST
Place cabinet on a level
surface. Slowly remove chest
from the cabinet.
6UNLOCK OR LOCK
THE DRAWERS OF THE
TOOL CHEST
Distributed by:
GREATSTAR INDUSTRIAL USA, LLC
9836 Northcross Center Court, Suite A,
Huntersville NC 28078, USA
www.greatstartools.com
WORKPRO