WSTER WS-858 User manual

USER MANUAL
WS-858 Wireless Karaoke Microphone

1.PHOTOGRAPH

2.INSTRUCTIONS
HOW TO USE
1. Switch on/off: Press the power button, the blue light will be on/off
2. Bluetooth connection: Turn on bluetooth on your mobile phone,
and search the bluetooth name ’WS-858’, click and pair.
3. Playing music: Tum on mobile phone music app,
download your favorite songs or accompaniment songs,
volume could be adjusted by cellphone.
4. Adjusting sound: Adjust voice volume or echo in suitable place.
5. Start singing and have fun!
HOW TO RECORD
1. Connect the audio cable, plug the micro USB port into pocket
and 3.5mm audio port into cellphone.
2. Open recording app like Apple Music and follow the using process,
Start recording.
PS: Bluetooth will automatically disconnect when audio cable plug in.

3.FAQS
Status Reasons Solutions
LED does not light Low power or charging Charge or check the
cable not plugged in charging cable
Microphone not working Can’t be turned on or the Switch on or adjust
voice volume can’t be voice volume
adjusted
No Reverberation Echo key not adjusted Adjust Echo to a
suitable place
Presence of noise Environmental noise Adjust the distance
Mobile phone signal between microphone
Interference and cellphone
Poor Recording Phone does not match, Restart the phone to
Phone chip processing try again or replace
ability that is weak the phone
When playing music, Distant Bluetooth Close to mobile phone,
Staccato appears connection or keep away from
Obstructions between obstructions
Phone and device
Accompaniment Mobile phone volume Higher phone volume
Sounds weak or no low or music file download high quality
Sound quality bad music
Bluetooth can’t be Distant bluetooth Get closer to phone or
Paired connection or already disconnect with previous
paired with another phone phone
Sound distortion when Volume too high, battery Lower phone volume
playing music power is too low charge device

4.HOW TO CHARGE
1. When the battery voltage is too low, the product will
automatically turn off;
2. Using USB cable to connect with mobile phone standard jack,
then the red light will be on;
3. Normal charging 4 hours, charging is completed, the red light is
automatically extinguished
4. Normal conditions work 4 hours.
5.SPECIFICATIONS
Microphone: Capacitance
Output power:5W/6W (Speaker Output)
Frequency Range:100Hz-10Hz
Maximum sound pressure level:>115dB 1KHz THD<1%
Reverb Mode：Echo sound reverberation
Power Supply: Build-in-Li-ion Battery
Battery Capacity:1800mAh
Charging Voltage: DC 5V=1A

6. SERVICE DESCRIPTION
If you have any problems with the microphone, please don’t
hesitate to contact us, we have 24-hour friendly customer
service for you at: [e-mail]
FCC Requirement
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.