WYLER Multi TC User manual

Technical changes reserved. 1/ 2 947-QR-002-E
Quick Reference Multi TC Release 1.0
WYLER AG
Im Hoelderli 13 E-Mail: [e-mail] Outside Switzerland:
8405 Winterthur Tel. [phone] contact our representatives
Switzerland Website: www.wylerag.com www.wylerag.com/en/contact/representatives/
Thank you for choosing WYLER!
Read this quick reference before start working with the Multi TC.
Please note the safety instructions.
Brand and Type
Brand: Multi TC
Type: 065-003-000-001
Warning! The following sign is used in this Quick Reference:
This is intended to indicate special danger.
Safety instructions
The Multi TC complies with the applicable directives and standards, see:
-This Quick Reference
-The type label
- The CE Declaration of Conformity at www.wylerag.com
Intended Use
-The MultiTC is a system component and interface. It is designed exclusively to connect WYLER products
which are equiped with WyBus dll.
-Attention!: There is no other use allowed!
Not intended use
-Do not use as a hammer!
-Do not throw the device! The housing can cause serious injury.
-Do not use this device near sources of strong electromagnetic energy Radiation (e.g.,
unshielded radio frequency source) because they can interfere with operation.
DC-Characteristics Common Characteristics
Characteristics Value Characteristics Value
Power Supply +24V 12 – 30 V Interfaces RS232 on Port 0
Power Supply +5V 4.5 – 5.5 V RS485 on Port 1,2,3,4
Power Consumption max. 450 mW Connectivity Wyler USB-Cable
Input Low Voltage 0.8V wylerCONNECT
Input High Voltage 2.4V Temp. (Operation and use) -40 .. 85° C
Dimensions: Pinout Port 0:
WARNING
WARNING
Pinout Port 0, 1, 2, 3, 4:
Pinout
Please Note: To lock the connectors, the
threaded ring is tightened until it is ‘finger-
tight’ (approx. 50 Ncm)

Technical changes reserved. 2/ 2 947-QR-002-E
Quick Reference Multi TC Release 1.0
Standard scope of delivery: Multi TC, Quick Reference (data sheet: www.wylerag.com)
Configuration
ATTENTION
The MultiTC can handle only one protocol
at the time.
That means, you can connect only
measuring instruments and sensors
belonging to the same group to the
MultiTC.
Decommissioning, disposal
When decommissioning the Multi TC, follow the local regulations for disposal of
electronic waste.
WARNING
Configuration product group 2
Configuration product group 1
Group 1
Group 2