X2 M1 HD + U.S Edition User manual

E. Troubleshooting
Problem Solution
For satellite tuner module
Check the LNB; Replace the LNB if necessary.
Check the cable from the LNB.
Check the position of the dish; realign dish if necessary.
If you are using a DiSEqC 1.0 switch, check that you have
connected and programmed the LNBs to the
correct connections on the switch.
See “No Picture” above.
Check the signal level, if this is low then tries adjusting the
alignment of your dish.
Check the main power cable and check that it is plugged into a
suitable power outlet.
See “No Picture” above.
Check the volume level of the TV and STB.
Check the Mute status of the TV and STB.
Point remote control directly towards the STB.
Check that the STB button lights up when you press any button.
Check and replace batteries.
See “Does not display any meessage on the front panel” above.
To match the STB system with your TV system (PAL/NTSC),
Press TV Format "DISPLAY" Button until a picture is displayed.
Check the video output port is firmly connected to the TV or VCR.
Check that you have selected the video Input on your TV.
Check the brightness level of the TV.
Check the resolution that your TV supports, and set the proper
resolution with the remote Resolution button
to obtain a picture.
No or Bad Signal
No Picture
poor picture quality
Does not display any
message on the front panel
No Sound
Remote control does
not operate
Common features for all types of DVB receivers
Check the “Signal Level” and the “Signal Quality.”

7