Xhorse XC-MINI User manual

List of rechargeable battery of XC-Mini
①Mainboard
②Cable of 6 & 7
③Battery charger & display module
④Vehicle charging line
⑤Adaptor 220V
Specification of rechargeable battery of XC-Mini
Standard voltage 25.9V
Limited charge voltage 29.4V
Rated Capacity 2500mAh
Power Ra 73.5Wh
www.xhorsevvdi.com
Contact Info:
Email: [email protected]
Skype: xhorsevvdi.com
Whatsapp:[phone]

Instruction of how to change the built-in battery of XC-MINI
郑重提醒：为确保安全，以下所有操作需在断电情况下进行。
Remark: please follow the procedure to operation in case of damage the Mainboard ,do not
connect the power during operation
1 , Take off those 4 screws like the picture
show
Attention : For your security, do not connect the power in next steps
2 , Push the motor inside and hold the white buckle then take
out the emergency-stop module like the picture show
3 , Loose the connection of position 11 &12 like picture show
www.xhorsevvdi.com
Contact Info:
Email: [email protected]
Skype: xhorsevvdi.com
Whatsapp:[phone]

4 , Use a screw to make the connection those two cables what are from position 11 & 12
like the picture show ,and use the acetate tape fix the connection well
5, Fix the cable 6 to the position 12 , cable 7
for position 11 , then put the emergency –
stop module back and fix it well
6, Take off those 2 screws like picture
show
7, Turn over the XC-MINI and take off the foot rubber and
screws like picture show ,
8, Take out the Power-board and disconnect all cables
like picture show
www.xhorsevvdi.com
Contact Info:
Email: [email protected]
Skype: xhorsevvdi.com
Whatsapp:[phone]

11, Fix the cable of 24V and
cable of GND in the right
position like picture show
10 , Fix the cable into the socket according the
number between the cable and socket ,make
sure very cable will be fix well ,
9, Use the battery charger & display
module to replace the original power
interface like picture show
Battery charger & display module
Original Power interface ( 220V)
13, Fix the all cables after put back the
mainboard , the mainboard should be in
fixed very solid ,manage the cables again if
not , then fix the foot rubber and screws
12, Connection the power like picture
show then put back the Mainboard and
fix it well
www.xhorsevvdi.com
Contact Info:
Email: [email protected]
Skype: xhorsevvdi.com
Whatsapp:[phone]

Remark : electricity volume will be show by the green light , the LED that is mark ‘’ CHRG ‘’
should be green if it is charged , it will be red during charging
14, Fix those screws like picture show 15 , The screen , LED , display of battery
charger should be on after you press the
emergency –stop button , if not ,check the
connection again
www.xhorsevvdi.com
Contact Info:
Email: [email protected]
Skype: xhorsevvdi.com
Whatsapp:[phone]