Xkitz XAPS-10WB User manual

4/11/2020 XKITZ XAPS-10WB
1
Audio Grade DC Power Supply, 10W, Bi-Polar
Model XAPS-10WB
User Instru tions
Rev 1.0
Xkitz. om
Features
•Designed spe ifi ally to power the fully balan ed a tive rossovers XOVER-2B and XOVER-3B
•Output voltage: +-20V
•Output Current: 300mA sustained on ea h rail
•Large filter aps for lean, solid, output
•Support 115V or 230V AC mains input
•Dimensions: 4.5” x 2.25” x 1.125” High (114mm x 57mm x 29mm)
Figure 1. Connections and Dimensions
0.15"
2.25"
•Select 115V or 230V AC mains voltage on the selector switch.
•Connect AC Mains in ut voltage to AC1 and AC2 terminals
•O tionally connect earth ground to ‘EARTH’ terminal.
•Connect u to 3 crossover boards to ‘DC VOUT’ connectors. The voltage, current
ca acity, and in-outs are directly com atible with the XOVER-2B or XOVER-3B
active crossover boards from Xkitz. No cutting or s licing is needed.

4/11/2020 XKITZ XAPS-10WB
2
Powering the XOVER-2 or XOVER_3 Crossovers
The XAPS-10WB was designed primarily to power the XOVER-2B or XOVER-3B fully balan ed rossovers,
but it an also be used to power the XOVER-2 or XOVER-3 rossovers. These rossovers use only a single
positive power supply, so the (-) outputs of XAPS-10WB will not be used.
You’ll need to ut off the snap-in onne tor on the rossover side of the able (sin e the XOVER-2/3
boards have a terminal blo k for power supply onne tion). Just onne t the enter wire (GND) from the
power supply to the (-) input on the terminal blo k and onne t the (+) wire from the power supply to the
(+) input on the terminal blo k. This will give the rossovers approximately 22-24V DC, whi h is ideal for
the XOVER-2/3 boards.
Leave the wire from the (-) output of the power supply un onne ted, or just ut it off, it won’t be needed.