Xtool D1 Pro User manual

04
xTool D1 Pro 40 W
Laser Module Kit
KD010553000
04
xTool D1 Pro 40 W
Laser Module Kit
KD010553000

xTool D1 Pro 40 W laser module kit provides two color options. This user manual
uses the golden red version to describe how to modify and set up your machine.
List of items
Modify your xTool D1 Pro
Set up the machine
Use the focal length setting piece for
the infrared laser module
Clean the laser module
Instructions
03
06
38
43
46
51
01 02

03
List of items
04
Middle platePosition limit piece A Position limit piece B
Main control board Laser module Position limit control board
Power adapter Parts storage boxCable tie pack
Screwdriver Focal length
setting piece
Hex key
Screw M4*16 Screw M4*25
Cylindrical head
screw M3*6

05 06
Modify your xTool D1 Pro
Sharp-nose pliers
1. Remove the original middle plate
With this xTool D1 Pro 40 W laser module kit, you can modify
your xTool D1 Pro into a 40 W one.
Cylindrical head
screw M3*8
Round head
screw M3*10
Flat head
screw M3*8

07 08

09 10

12
11

14
13
2. Replace the position limit control board
If the position limit control board cannot be removed due to screw slipping, use the
sharp-nose pliers to remove it. Exercise caution when doing this, protecting yourself
from hurt.

16
15
3. Replace the position limit pieces

18
17
4. Replace the main control board
(1) Remove the original main control board
The largest processing area varies according to laser module. You need to set the
position of position limit piece A, accordingly.
(1) (3)(2)
For laser module 40 W For laser module 20 W For laser module 10 W & 5 W

20
19

21 22
(2) Install the new main control board

23 24
5. Install the shaft and coupling back to the machine
If you can't put the shaft
through the timing belt, the
possible cause is that the
timing belt is set too tight.
You can adjust its tension by
turning the screw.

25 26
Keep a small distance between the coupling and motor, or the coupling
can't rotate properly.
Do not tighten the screws here. Slide the two sliders down against the front plate.

27 28
6. Install the new middle plate
Fully tighten the two screws. Cut off the white cable ties, and keep the black ones.

29 30

The screw is used to set the tension of the timing belt. Do not fully tighten it.
Otherwise, the timing belt may be damaged.
31 32

There are three holes designed for cable ties on the right plate. Do not attach
a cable tie in the middle hole. It may interfere with the moving of the laser
module.
33 34

7. Install the new laser module
35 36

Set up the machine
1. Adjust the tension of the timing belt on the right plate
Try to set the tension of the timing belt on the right plate to be the same as that
of the timing belt on the left plate to ensure better engraving and cutting results.
Modification completed!
37 38