Correction key combination: [VOL+] & [VOL-]
The remote can enter the calibration state under the Bluetooth connection state. At
the same time, press the calibration key for about 3 seconds, and the A-side BLE
work indicator light is on to indicate that the calibration state is entered, and the
remote controller is placed on the stationary horizontal desktop. After a few seconds
(about 5 s) the calibration is successful, and the work indicator flashes three times
and then goes out.
5.one-way voice function:
A side has a voice function key. The box is Google Voice Assistant, the standard
Google Voice mode of operation.
Regardless of whether the button is released or clicked, the remote control
immediately sends a HID CODE to the device, and the device terminal pops up the
Google Voice Assistant to start the tone, and then the remote controller starts to
upload the voice to the device.
6.Bluetooth power service and low voltage prompt function:
The remote control has an automatic power detection function. When the BLE part
of the remote control is connected to the device, pressing the button, the Bluetooth
power service will report the power information to the device. The device displays
the corresponding percentage of charge.
When the power is lower than 2.4V, each time the button pressed the button, the
A-side BLE work indicator will flash 5 times to indicate that the battery is low.
7.keyboard surface Fn key combination function:
There are two states on the B side of the remote control keyboard surface, one is the
normal state (also the default state), and the other is the Fn state (there is a Fn state
switching dedicated key and an Fn status indicator, which is bright in the Fn state,
normal state To extinguish.)
Power the remote control, if there is no state selection in front of the keyboard, it is
the normal output state, press the button to send the key value of the white silk
screen button.
Press the Fn button, the Fn light is on, the keyboard surface is in the Fn state, and the
orange-red silk screen button key value in the upper right corner of the output
button is output. The button without the orange-red silk screen sends its own key
value. In the Fn state, the button with the Shift key can output the key code of the
orange-red silk screen button in the lower right corner of the button.
8. the indicator description:
Indicator light: 2 on the A side and 2 on the B side
