Y5Home 4 Module Switch User manual

Installation Guide
Y5Home 4 Module Switch

Configure Switchboard Module
Note: Switchboard module MUST be configured into Y5Box before
installing it behind the switchboard panel
Follow the below mentioned steps to connect the switchboard
module with Y5Box using the Y5Home App:
• Open Y5Home App (in mobile, desktop or TV)
(<ip address:3030> for Y5Home browser link)
• Click on “Y5Home Smart Automation” widget on homepage
• Click on “CONFIG MODULES” tab
• Check “Module Config” check box
• Add 16 char module ID in module
id field (You can see 16 char
module id address on switchboard
module as a barcode)
E.g. 01234567ABCDEF01
• Click on “Configure” button
• After few seconds module will be
displayed with red icon

• Now you can install
the Y5 Switchboard Module
behind the switchboard panel
• After few minutes red icon will be
disappear and module will be
ready to use
Wiring Basics
• Y5-04 module supports dimmable device on 1st switch only
• Load 1,2 & 3 MUST have the same power source, i.e. they should all
be either on municipal power, or UPS or generator
• Load 4 can be on a different power source (High amp line)
e.g. in a washroom switchboard geyser could have a different
power source (16A) compared to the lights.
Y5-04
Dimmer
Load
Devices
1st Switch
Yes
300W
Bulb, Fan
2nd Switch
No
1500W
TV, CFL, Tube Light, Table Fan etc.
3rd Switch
No
1500W
Lamp, Mosquito Coil etc.
4th Switch
No
2500W
2 TON AC, Geyser, Window AC, 3-
Phase Plug with Low Load(2500W)
Note: If you are not confident of handling electric wires, you can call Y5Home
affiliate or your local electrician
Rating of each load is specified in above table. Y5Home is not responsible
for damages done by devices with higher rating installed on load

Neutral
Phase
Before Installation
Wiring Connections
Switch 3 Switch 4
Neutral
Phase for AC
Y5-04
Switch 2
Device 4
(AC)
Neutral
Switch 2
After Installation
Device 1
Switch 1
Phase
Switch 1
Device 1Device 2Device 3Device 4
Phase
Switch 1 Switch 2
Phase
Device 3
Device 2
Device 1
Phase
Switch 4 Switch 3
Switch 3
Switch 4
Neutral

Installation of Fan with Y5-04 - 1st Switch
Before Installation After Installation
Neutral
Phase
Switch
Fan
Neutral
Regulator Bypassed
Phase
Switch
Fan
Y5-04
Regulator

For questions or clarifications write to us at [email protected]
Installation with 2-way switches
After Installation
Phase Device
Y5-04
Phase Device
Before Installation