Yale HDC-303G User manual

Description
1. Camera Lens. Automatically detects
changes in light levels to switch between day
and night vision
2. Infra-red LED for night vision
3. Use supplied hex key to adjust camera
angle
4. Video output (BNC male connector)
5. Power input (12V 500mA)
Inside the Box
• 2 x Outdoor Cameras
• 2 x 15m BNC/DC extension cables
• 1 x 12V 500mA power adaptor
• 2 Way splitter
• 1 x fixing pack and hex key
smart
Living
HD Outdoor
Camera
(HDC-303G/HDC-403G)
For more information on this product
and Yale Smart Living Range visit
www.yale.co.uk/smart-living
Consumer Support: [email protected]
2
The 2 year guarantee for this
product is active from the date
of purchase (A copy of this
guarantee is available on our
website).
2
1
3
4
5
Compatibility
Compatible with Yale Smart HD
CCTV Systems only.
Connecting your Camera
Connecting to your DVR
15m
BNC/DC cable
DVR
rotpadA
*Do not switch on the socket
until everything is connected.
15m
BNC/DC cable
rotpadA
BNC male to
RCA male
adaptor
*not supplied
TV
*Do not switch on the socket
until everything is connected.
supplied
15m
BNC/DC cable
DVR
rotpadA
*Do not switch on the socket
until everything is connected.
15m
BNC/DC cable
rotpadA
BNC male to
RCA male
adaptor
*not supplied
TV
*Do not switch on the socket
until everything is connected.
supplied

Note: Waste electrical products and batteries should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Issue No. 1B
Information and illustrations are subject to change. Yale reserves the right to
alter the specification and product design at any time without notice.
Mounting the Camera
The Stand on the camera is adjustable
at 3 points.
1. Adjust the camera angle by loosening the
hex screw (using the supplied hex key). Once
in position, tighten the screw again to secure
into place.
2. Adjust the elbow joint by loosening the hex
screw. Once in position, tighten the screw
again to secure into place.
3. Where the neck of the stand attaches to
the mounting base, loosen the locking ring to
rotate the stand. Once in the desired position,
tighten the ring again to secure into place.
To mount, use the supplied screws and tighten
the mounting plate against the flat surface.
Troubleshooting
Video Loss
If no video stream can be viewed on your
TV, Monitor or DVR:
• Check the extension cable is connected
to the camera.
• Check the video output from the camera
is securely connected to a video input
channel on the DVR.
• Check the power from the camera is
connected to the power adaptor,
connected to a power supply and
switched on.
12
3
Bright Spots at Night
When I view an image from the camera at
night I can only see a bright spot with no
image.
This can be caused by a reflection from
the camera’s built in infra-red LED’s looking
through a window. Move the camera to the
other side of the window or to a different
location.
Specification
Video
Image Sensor: CMOS
Video Quality: High Definition
Minimum Illumination: 0 Lux (IR on)
Day/Night Mode: Colour in lit up areas/black
& White in dark (IR on)
Lens: Fixed 3.6mm
Viewing Angle: 60 Degrees
Night Vision
Nightvision distance 30 metres
IR Cut Filter for enhanced night vision
Infra-red LED’s
General
Indoor/Outdoor use
Operating Power: DC 12V/500mA
Dimensions: 80mm(W)x190mm(L)x90mm(H)