Yamaha 02R User manual

AUDIO-SERVICE GMBH
02R Faderupgrade Installation
Audio-Service Ulrich Schierbecker GmbH
Schnackenburgallee 173
22525 Hamburg/Germany
Tel. : [phone]
FAX : [phone]
E-MAIL: [email protected]

Audio-Service
Attention: Before you start the Installation
" Disconnect the 02R from MAINS "
Disconnect all externel Equipment
Opening the 02R Cover
1. Remove 18 Screws like discribed in the drawing above
Open the 02R`s Topcover
4 x Screws located under the front of the 02R
6 x Screws " left and right of the 02R Frame
4 x Screws on the Backside of the 02R

Audio-Service
Opening the 02R Frontpanel
2. The 02R`s Frontpanel is fixed at the Faderside via a hinge, so if you open the
panel you should use a Stay to fix the panel in the opened position.

Audio-Service
3. Remove the Connection`s of the Faderpanel
Remove Cable connected to :
CN 361 = Power Supply Board;
CN 361; CN 362; CN 363;CN 364; CN 365. = SubCPU Board.

Audio-Service
5. Connectors disconnected

Audio-Service
6. Move the Fader in the middle position ánd remove the Faderknobs.
Remove all Faderpanelsrews from the Frontpanel.
7. Carefully take the Faderpanel out of the Frontpanel

Audio-Service
1. Opened 02R showing the back of the Frontpanel without the Fader Module
2. Insert the Fadermodule in the Frontpanel

Audio-Service
3. Now it should look like on the two Pictures above

Audio-Service
4. Place the smal metal bar like it is visible at the Pictures above

5. Carefully push the Metalbar(Circuitboardholder) under the Switch
Circuit Board and move the Metallbar 90 degree down.
6. Now place the Metalbarscrews on the Faderchassis to fix the Bar, but do
not thighten this screws, because you need to adjust the Boardholder.
Place all the screws connecting the Switchboard and the Metalbar, don`t
thighten them!
7. Now thighten the Metallbarscrews on the Faderchassis, then thighten
the screws connecting the switchboard.