FCC INFORMATION
(for
US
customers
only)
1.
IMPORTANT
NOTICE:
DO
NOT
Compliance with
FCC
regulations does not
MODIFY
THIS
UNIT!
guarantee that interference will not
occur
in all
This product, when installed as indicated in the installations.
If
this product is found to
be
the
instructions contained in this manual, meets source
of
interference, which can
be
determined
FCC requirements. Modifications not expressly by turning the unit
"OFF"
and
"ON",
please try
approved by Yamaha may void your authority, to eliminate the problem
by
using one
of
the
granted by the FCC, to use the product. following measures:
2.
IMPORTANT:
When connecting this product
to accessories and/or another product use only
high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all
installation instructions. Failure to follow
instructions could void your FCC authorization
to use this product in the USA.
3.
NOTE:
This product has been tested and
found to comply with the requirements listed in
FCC Regulations, Part
15
for Class
"B"
digital
devices. Compliance with these requirements
provides areasonable level
of
assurance that
your use
of
this product in aresidential
environment will not result in harmful
interference with other electronic devices.
This equipment generates/uses radio frequencies
and,
if
not installed and used according to the
instructions found in the users manual, may
cause interference harmful to the operation
of
other electronic devices.
Relocate either this product
or
the device
that is being affected by the interference.
Utilize power outlets that are on different
branch (circuit breaker
or
fuse) circuits
or
install AC line filter/so
In the case
of
radio
or
TV
interference,
relocate/reorient the antenna.
If
the antenna
lead-in is 300 ohm ribbon lead, change the
lead-in to coaxial type cable.
If
these corrective measures do not produce
satisfactory results, please contact the local
retailer authorized to distribute this type
of
product.
If
you can not locate the appropriate
retailer, please contact Yamaha Electronics
Corp., U.S.A. 6660 Orangethorpe Ave, Buena
Park, CA 90620.
The
above statements apply ONLY to those
products distributed
by
Yamaha Corporation
of
America
or
its subsidiaries.
COMPLIANCE INFORMATION STATEMENT
(DECLARATION
OF
CONFORMITY
PROCEDURE)
This device complies with Part
15
of
the FCC Rules. Operation is subject to the following conditions:
1)
This device may not cause harmful interface, and
2) This device must accept any interference received including interference that may cause undesired
operation.
See user manual instructions
if
interference to radio reception is suspected.
FCC INFORMATION
(for
US
customers
only)
1.
IMPORTANT
NOTICE:
DO
NOT
Compliance with
FCC
regulations does not
MODIFY
THIS
UNIT!
guarantee that interference will not
occur
in all
This product, when installed as indicated in the installations.
If
this product is found to
be
the
instructions contained in this manual, meets source
of
interference, which can
be
determined
FCC requirements. Modifications not expressly by turning the unit
"OFF"
and
"ON",
please try
approved by Yamaha may void your authority, to eliminate the problem
by
using one
of
the
granted by the FCC, to use the product. following measures:
2.
IMPORTANT:
When connecting this product
to accessories and/or another product use only
high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all
installation instructions. Failure to follow
instructions could void your FCC authorization
to use this product in the USA.
3.
NOTE:
This product has been tested and
found to comply with the requirements listed in
FCC Regulations, Part
15
for Class
"B"
digital
devices. Compliance with these requirements
provides areasonable level
of
assurance that
your use
of
this product in aresidential
environment will not result in harmful
interference with other electronic devices.
This equipment generates/uses radio frequencies
and,
if
not installed and used according to the
instructions found in the users manual, may
cause interference harmful to the operation
of
other electronic devices.
Relocate either this product
or
the device
that is being affected by the interference.
Utilize power outlets that are on different
branch (circuit breaker
or
fuse) circuits
or
install AC line filter/so
In the case
of
radio
or
TV
interference,
relocate/reorient the antenna.
If
the antenna
lead-in is 300 ohm ribbon lead, change the
lead-in to coaxial type cable.
If
these corrective measures do not produce
satisfactory results, please contact the local
retailer authorized to distribute this type
of
product.
If
you can not locate the appropriate
retailer, please contact Yamaha Electronics
Corp., U.S.A. 6660 Orangethorpe Ave, Buena
Park, CA 90620.
The
above statements apply ONLY to those
products distributed
by
Yamaha Corporation
of
America
or
its subsidiaries.
COMPLIANCE INFORMATION STATEMENT
(DECLARATION
OF
CONFORMITY
PROCEDURE)
This device complies with Part
15
of
the FCC Rules. Operation is subject to the following conditions:
1)
This device may not cause harmful interface, and
2) This device must accept any interference received including interference that may cause undesired
operation.
See user manual instructions
if
interference to radio reception is suspected.
