Yard Craft VERTICAL GARDEN BED User manual

Natural Cedar
VERTICAL GARDEN BED
Assembly Manual
GARDEN BED KIT CREATES UP TO 8 SQ.
FT. OF GARDEN SPACE!
24.375”
47.25”
25.875”
15.5”
12”
Vertical Garden Bed
•5 cubic feet of soil to fill
•Creates 8 square feet of garden area

(2) Left Side End Boards
with Notches
(2) Angled End Boards
Step 2: Make sure all end boards are tight
together and fasten bottom trim board with 5
pre-drilled holes and top trim board with 2
pre-drilled holes with 1 ¼” screws as shown.
Repeat Step 1 & step 2. There
should be 2 panels as shown here.
Angled End Board
Vertical Garden Bed Assembly Manual
(2) Right Side End Boards
with Notches
(14) Shelf Boards
(2) Top Side Boards
(1) Small Bottom Shelf Board
(Marked)
(1) Big Bottom Shelf Board
(Marked)
(2) Bottom Shelf Blocks with 3
pre-drilled holes.
(2) Bottom Trim Boards
with 5 Pre-drilled holes
(2) Top Trim Boards
with 2 Pre-drilled Holes
(2) Top Trim Boards
with 4 Predrilled Holes
(34) 2” Screws
(28) 1 ¼” Screws
(1) #2 Square Drive Bit
(Included)
Screw Gun OR Screw Driver
(Not Included)
Step 1: Make sure top notches are on the
outside and shelf notches angle down
into the center as seen in Step 5. Fasten
Angled End Board to Left Side End Board
with (1) 2” Screw.
Right Side End Board
Questions? Issues with Damaged or
Missing Parts?
In order to best assist you, please contact
YardCraft directly, NOT a third part
retailer, with any questions regarding our
products, damages, or replacement parts.
This will help you get what you need as
quickly as possible! Call us at 866-210-
9273 or Email us at [e-mail]!

Left Side Panel
Step 4: Assemble marked big bottom shelf board
& marked small bottom shelf board. Center the
bottom shelf blocks on the big and small bottom
shelf boards and fasten with 1 ¼” screws into
pre-drilled holes as shown.
Vertical Garden Bed Assembly Manual
Right Side Panel
Step 3: Insert Shelf Boards in the bottom notch
as shown. Fasten from each side with 2” screws
into pre-drilled holes.

Vertical Garden Bed Assembly Manual
Step 5: Place bottom shelf panel in
place with blocks facing down as
shown. This shelve is free floating.
Step 6: Insert the rest of the shelf boards
into notch and fasten from each end with
2” screws into pre-drilled holes
Step 7: Insert top Side Boards into notch and fasten
with 2” screws on each side into predrilled holes
Last Step: Place top trim board with 4 pre-drilled holes,
on top, centered both ways and fasten with 1 ¼” screws