Yeong Yang YY-0221 Owner's manual

ZZ17-02101-B
YY-0221 Cube Case EEB3.0 version
Technical Instruction
I. INTRODUCTION
1. This Cabinet
YY-02XX is a server cabinet configured on PS2 power supply or a PS2
sized redundant power supply that takes using as a Server/Raid system.
Compatible with extended ATX, ATX motherboard.
2. Component Checklist
If assembling this chassis by yourself, it is important to prepare all the
chassis components before starting. This will save a great deal of time
by not having to hunt down components. The following checklist
provides a guideline as to the necessary components for a chassis.
Standard Components
Chassis YY-0221
Power Supply PS2 PSU or Mini Redundant PSU
Optional required Components
Cooling Fan 9cm cooling fan, 3pcs maximum
Cooling Fan 12cm cooling fan, maximum 1pce
EMI Filter EMI filter for tailgates
I/O Shield Various I/O shield
ZZ17-02101-B
II. System Assembly and Disassembly
1. Front Panel
Push the door (pointed) to open the door
for devices’ operation.
To assembly the front panel with
plugging two hooks of the bottom of
front panel, into the chassis body and
snaps the springs of front panel in.
2. Side Panels
There are two screws in each side, release
the screws, and open it like a door. There
is a fan space in the side panel, integrator
could figure it with or without fan depends
on system's request.
3. Power Supply Mounting
The chassis allows PS2 power supply with
bracket or mini redundant power supply.
Four screws are used to secure the power
supply to the cabinet backside.

ZZ17-02101-B
4. Install Storage Devices
To install 5.25” HDD or CD-ROM, it
should release the 5.25” device frame
from the cabinet body first.
Take the metal slides out from
5.25"device frame, and ensure the
metal slides should be fitted with device
in position.
Press the device inward, to take the
slides in along the rails of drive bay.
Fasten by (2) screws on front side.
To install 3.5”HDD in the 5.25”drive
bay, the metal shield could be
screwed in the front end for better EMI
result.
ZZ17-02101-B
5.
Install motherboard &
add-on-cards
Install I/O shield (putting from inside
of case).
Finding correct mounting hole for
M/B, screw in standoffs. Fasten M/B
with the screw. Install add-on-cards.
6. Cooling Fan mounting
Front mounted: Fasten 12cm fan from
outside of chassis by screw. Air flow
out is stronger suggested.
Rear mounted: Fasten 9cm fans from
outside of chassis by screws. Air flow
in is stronger suggested.
Side mounted: Fasten 9cm fan from outside of chassis by screws. This
vents could reserved as air flow in, no fan required. However, system
integrator could re-build the air flow depends on system's configuration. A
cooling fan could be installed in side cover, please watch out its cable
routing when side cover assembly.
7. Routing cables
8. Close the chassis
Close the door. Snap in front panel without screw.