- 3 -
Step 2: Connect the power adapter to an electronic socket and the DC IN port
of the device.
Step 3: Insert a memory card (with the card’s electrical contacts towards the
front of the unit) or USB flash drive in the Digital Picture Frame. A slide
show should begin automatically.
Step 4: In the slide show mode, you can:
gPress the button to display the previous or next picture.
gRepeatedly press the Rotate button to change time interval between
slides.
gRepeatedly press the MODE button to cycle through 3 display modes
– Pan Scan, Fill and Original
gPress the button to stop slide show.
Step 5: Briefly press the button to stop the slide show and enter the Single
Show mode. A tool bar will appear at the top right corner of the screen,
which indicates functions that you can use at the moment. The current
photo will remain on the screen until the button is pressed again, at
which time the slide show will resume.
In the Single Show mode, you can:
gPress the button to display the previous or next picture.
gPress the Rotate button to rotate the current picture clockwise:
90°ė180° ė270°. (it can only be operated when slide show is
stopped)
gPress the MODE button to cycle through 3 display modes –Pan
Scan, Fill and Original.
gPress the button to start slide show.
TechnicalNotes
1. Your Digital Picture Frame is a sophisticated electronic device. Do not drop
or subject the unit to jarring or strong vibrations.
2. Avoid placing the Digital Picture Frame in areas of high humidity or where it
might be subjected to splashing.
3. The panel is made of plastic and can be easily damaged. Avoid sharp
objects.
4. Use only a soft dry cloth to clean the screen.
5. The device does not guarantee the compatibility with all USB flash disks or
memory cards from various manufacturers. USB flash disks with special
features such as encryption, anti-virus etc. may not be supported.
