Zagg ID6BSF User manual

ID6BSF-*** Bluetooth Keyboard Function
One，LED Indicator
1，Blue LED：Bluetooth Coding Indicator
The Blue LED will flash per second, indicating that the
Bluetooth is connecting. The LED will stop after
successfully connected. If the LED is flashed without
connection for 1 minute, it will be off
2：Blue LED：Caps Lock
Caps Lock：on, caps on; off, caps off
2：Green LED：Power indicating and keyboard reset.
Power Indicating：When the power is 3.71V-4.2V/50%-
100%,the LED will flash per second with 3
cycles
Reset Indicating：When the keyboard is inserted with
5V USB cable line, the green LED will flash
for 2 second, then red LED on, indicating
that the keyboard has been reset. .
3：Yellow LED：Power Indicating
When the power is 3.5V-3.71V /25%-49%，The yellow
LED will flash per second with 3 cycles.
2，Reddish orange LED：Low power warning and charging
indicating.
Low power warning：When the power is 3.0V-3.4V/0%-11%,The
LED will last for 0.5 second, three times per
five minute.
Charging Indicating：The LED will be on until the power
is over 90%.

Two，Coding function
Press on the Bluetooth keycap for 3 seconds indicating
that the keyboard is connecting.
Three，Sleep function(Power saving mode):
The keyboard will run into sleep code if it weren＇t
used for 20 minutes. When typing again, the Bluetooth
will be automatically connected.
Four：Keyboard off
Press the power key for 3 second, the connection will
be off and the keyboard will be off.
Five，Other functions for the keyboard: the same with
layout
Six，Remarks
1，Coding: Bluetooth comparing indicating.
2，Ordinary use: no LED indicating
3，Lowing power connecting: the low power warning will be
on after the Bluetooth is successfully connected.
4，Using in low power condition：Low power warning.
5，Using when charging: the keyboard will be charged
after the Bluetooth is connected.
6，Using when charging: the charging indicator will be on.

FCCWarning

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.