13
Pull the electric cable out of the storage recess
in the back of the appliance.
Before inserting the plug into the
power socket, carefully check that the
voltage and frequency quoted on the
rating plate correspond to your home
electricity supply.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
If the plug that is fitted to your appliance is not
suitablefor yoursocketoutlet,itmust becutoff
and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into a 13amp socket in another part
of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
Ifyoufityourown plug,thecoloursof thewires
inthemains leadofyourappliancemaynotcor-
respond with the markings identifying the ter-
minals in your plug, proceed as follows:
The manufacturer declines all responsibility
if these safety regulations are not complied
with.
Electrical connection
Important
Connect the Green and Yellow (earth) wire to the ter-
minalin theplugwhichis markedwiththeletter «E»or
the earth symbol , or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or coloured
red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BSI362 fuse. Only ASTA
or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured
insert at the base of the plug.
Oz completo GB 19-05-1999 15:54 Pagina 13