zapco Z-BR II User manual

Z-BR II
Owner’s Manual
Before operating the unit, please read this manual throughly and retain it for future reference.

The Zapco Z-BR II Dash Remote
An accessory remote level control for the following Zapco Amps:
Z-II Series, Z-SP Series
The Zapco Z-BR II adds new versatility to let you find the best looking and most
convenient mounting for your new remote. You can mount the Z-BR II under
dash with the solid metal housing or you can disassemble the housing to remove
the bare pot for in-dash mounting.
If you remove the 2 screws from the housing it will slide back and off the remote
leaving just the remote and top bracket. Then remove the knob and you can take
the bare remote out of the bracket for mounting in a dash or other convenient
panel. We have included two knobs with the Z-BR II. The 20 mm knob is included to
match the size, look and feel of the volume control of most common head units.
The 13 mm knob is useful in a crowded dash where finger clearance is needed. It
also provides more clearance when mounting the remote under the dash.

Cross section of the Z-BR II shows:
1. Front remote bracket
2. Removable rear housing
3. Screws that release the
housing
For mounting in a dash or other panel you
must drill a 5/16 hole for the shaft of the
Remote. The two sets of Nuts and washers
allow the Z-BR II to be mounted in panels of
different thickness.
1
2
3

Modesto, California USA
Since 1974
zapco.com