Zinwell WB68 User manual

“”
installation
guide
Hey, I’ve Got a Multi-Switch!
Now what?
ZINWELL
ZINWELL
DIRECTV Approved
Indoor/Outdoor Wideband
6x8 Multi-Switch
Model WB68
Multi-Switch IG-half.indb 1Multi-Switch IG-half.indb 1 9/6/05 1:34:41 PM9/6/05 1:34:41 PM

1
General Information
The Zinwell WB68 is a DIRECTV-approved, 6x8 multi-switch, designed to expand the new Ka/Ku Satellite Dish
Antennas from 4 outputs to 8 outputs, supporting up to 8 independently operating receivers. The WB68 supports all
DIRECTV® Receivers, but is specially designed to work with the newest MPEG4-capable DIRECTV HD Receivers,
such as the model H20.
The WB68 supports up to two additional inputs using “Flexports” from satellites at locations such as 95° West
Longitude (W.L.) and 72.5° W.L.
If you connect an older (non-MPEG4-capable) DIRECTV Receiver that has the auto-configure feature to the WB68,
do not use the auto-configure feature; manually selecting the dish type will speed up the installation process. If you
do run the auto-configure feature, and you have multiple receivers, run auto-configure on only one receiver at a time,
and before running, make sure the other receivers are using a channel on the satellite at 101° W.L. (Channel 100 is
suggested.) This will reduce data acquisition time and minimize error.
The WB68 is passive, powered only by the connected DIRECTV Receiver(s). There is no retail equivalent multi-
switch. Flexports require selection codes unique to DIRECTV; other ports can be accessed with either tone/voltage or
selection codes.
The WB68 can be used to replace a SAM-6802 narrowband 6x8 multi-switch. The SAM-6802 is being phased out.
For technical
support,
please call
Zinwell Corp.
[phone]
Do not call
DIRECTV.
Multi-Switch IG-half.indb 1Multi-Switch IG-half.indb 1 9/6/05 1:34:45 PM9/6/05 1:34:45 PM

2
Installing the WB68
1. Use RG-6 coax cable with a solid-copper center connector. Other types of cables may cause more voltage
drop that will result in poor or no signal to the receiver. Note: e RG-6 cable should have proper exterior
waterproof connectors.
2. Mount the WB68 in a protected environment where it is shielded from rain and other water (sprinklers, etc.).
3. Use F-Connectors rated to at least 2150MHz.
4. Minimize the number of splices or connections between the WB68, the satellite dish and your DIRECTV
Receivers to minimize signal reflection and signal strength drop.
5. If you have more than one DIRECTV Receiver connected to the WB68, run Guided Setup on each, one at a
time.
6. Make sure the other receivers are configured for satellite 101° W.L., and tuned to Channel 100. This will reduce
setup time and minimize error.
OUT4 OUT6 OUT7 OUT8 OUT1 OUT2 OUT3 OUT5
DIRECTV-approved part
ZINWELL
®
Part #: WB68
Ka/Ku bands
250-750 MHz
950-1450 MHz
1650-2150 MHz
(Field Support # 1-909-718-0555)
Lot : 5 0 5 0 5
22KHz 22KHz
Sat 99 /101 Sat 103 /110 /119
18V 13V 18V 13V FlexPort 1 FlexPort 2
To Sat e lli t e Rec eive rs
To Di s h An t enna s
F-Connector and
RG-6 Cable
Multi-Switch IG-half.indb 2Multi-Switch IG-half.indb 2 9/6/05 1:34:45 PM9/6/05 1:34:45 PM

3
IMPORTANT: This multi-switch should never be used in a system containing a Frequency Translation Module (FTM). The equivalent
function of this multi-switch is already contained in the FTM. Combining this multi-switch with an FTM could result in your DIRECTV
System not working. If you don’t know whether you have an FTM installed, check with your installer or see the installation guide for
your dish antenna.
Important
Technical Information
The Ka/Ku satellite dish has “traditional” 101°/110°/119° W.L. LNBs and two additional Ka LNBs for 99.2° W.L.
and 102.8° W.L. satellite, respectively, hereby called 99° W.L. and 103° W.L. LNB for simplicity.
The stacked signal at each output of the dish antenna or the 6x8 multi-switch follows the frequency plan below. The
actual signal availability varies depending on user location and DIRECTV satellite deployment dates:
Stack Plan
Ka-Lo, 99° RHCP
Ku, 101° RHCP
Ka-Hi, 99° RHCP
Ka-Lo, 99° LHCP
Ku, 101° LHCP
Ka-Hi, 99° LHCP
Ka-Lo, 103° RHCP
Ku, 119° RHCP
Ka-Hi, 103° RHCP
Ka-Lo, 103° LHCP
Ku, 110°/119° LHCP
Ka-Hi, 103° LHCP
Output IF
Frequencies
Ka-Lo: 250-750 MHz
Ku: 950-1450 MHz
Ka-Hi: 1650-2150 MHz
Ka-Lo: 250-750 MHz
Ku: 950-1450 MHz
Ka-Hi: 1650-2150 MHz
Ka-Lo: 250-750 MHz
Ku: 950-1450 MHz
Ka-Hi: 1650-2150 MHz
Ka-Lo: 250-750 MHz
Ku: 950-1450 MHz
Ka-Hi: 1650-2150 MHz
Adding Receivers to the Flexports
Consult the Installation Guide for your Satellite Dish for 6x8 setup procedures.
With an older (non-MPEG4-capable) satellite receiver, if you have either 72.5° W.L. or 95° W.L. inputs, always
use FlexPort 1. If you have both 72.5° W.L. and 95° W.L. inputs, use FlexPort 1 for 72.5° W.L. and FlexPort 2 for
95° W.L.
Do not diplex (combine) an off-air signal with a Ka/Ku dish signal, since the Ka-Lo band of 250-750 MHz occupies
the same frequency band as the off-air signal and will cause interference.
Multi-Switch IG-half.indb 3Multi-Switch IG-half.indb 3 9/6/05 1:34:46 PM9/6/05 1:34:46 PM

4
Installing the WB68
(Ka/Ku dish not shown. Appearance of LNB may vary depending on brand.)
110°/119° W.L. Ku LNBs
Ka/Ku LNB (99°/101°/103° W.L. LNBs)
Two RG-6 cable runs, max. 100 ft total
72.5° W.L. 95° W.L.
Each of these 4 cables
can go into any one of the
4 LNB connectors.
B-Band Converter Module (BBC Module, SUP-2400)
All outputs are identical.
B-Band Converter Module (BBC Module, SUP-2400)
MPEG4-capable HD Receiver
MPEG4-capable HD Receiver
Non-MPEG4-capable Receiver
Non-MPEG4-capable Receiver (Local Channels are 2-digit numbers.)
(Local Channels are 3-digit numbers.)
OUT4 OUT6 OUT7 OUT8OUT1 OUT2 OUT3 OUT5
DIRECTV-approvedpart
ZINWELL®
Part #:WB68
Ka/Ku bands
250-750 MHz
950-1450 MHz
1650-2150 MHz
(FieldSupport # 1-909-718-0555)
Lot : 50 5 0 5
22KHz 22KHz
Sat 99 /101 Sat 103 /110/119
18V 13V 18V 13V FlexPort 1 FlexPort 2
Multi-Switch IG-half.indb 4Multi-Switch IG-half.indb 4 9/6/05 1:34:47 PM9/6/05 1:34:47 PM

5
(Appearance of LNBs may vary depending on brand.)
With Phase III, 18”x20”
DIRECTV Multi-Satellite Dish Antenna System
(dishes not shown)
With 18” Round DIRECTV Dish Antenna System
(dishes not shown)
Low-loss Addition of Terrestrial HD Signal
or Off-Air Signal to Satellite Signal
(For Non-MPEG4-capable Receivers Only)
95° W.L.
or
72.5° W.L.
Integrated,
triple-head LNB
95° W.L.
or
72.5° W.L.
Each of these
4 cables can
go into any one
of the 4 LNB
connectors.
Each of these
2 cables can
go into any one
of the 2 LNB
input connectors.
Dual
LNBs
only
101° W.L.
Terrestrial or
HDTV
Signal In
Duplexor as Separator.
Delete if Separator is
built into the satellite
receiver. Check
applicable satellite
receiver user’s guide.
NOTE: Do not diplex off-air signals for H20/MPEG-4 capable HD receivers
or BBC Modules when connected to a Ka/Ku Dish, since Ka-Lo band of
250-750 MHz occupies the same frequency range as the off-air signal.
Duplexor as Combiner.
Check with suppliers
for DIRECTV-approved
Dual or Quad Combiners.
Any 1 of 8 outputs
To
Satellite Receiver
ZINWELL
ZINWELL
To
TV
OUT4 OUT6 OUT7 OUT8OUT1 OUT2 OUT3 OUT5
DIRECTV-approvedpart
ZINWELL®
Part #:WB68
Ka/Ku bands
250-750 MHz
950-1450 MHz
1650-2150 MHz
(FieldSupport # 1-909-718-0555)
Lot : 5 0 5 0 5
22KHz 22KHz
Sat99 /101 Sat 103 /110 /119
18V 13V 18V 13V FlexPort 1 FlexPort2
OUT4 OUT6 OUT7 OUT8OUT1 OUT2 OUT3 OUT5
DIRECTV-approvedpart
ZINWELL®
Part #: WB68
Ka/K u bands
250-750 MHz
950-1450 MHz
1650-2150 MHz
(FieldSupport # 1-909-718-0555)
Lot : 5 0 5 0 5
22KHz 22KHz
Sat 99 /101 Sat 103 /110 /119
18V 13V 18V 13V FlexPort 1 FlexPort 2
OUT4 OUT6 OUT7 OUT8OUT1 OUT2 OUT3 OUT5
DIRECTV-approvedpart
ZINWELL®
Part #: WB68
Ka/K u bands
250-750 MHz
950-1450 MHz
1650-2150 MHz
(FieldSupport # 1-909-718-0555)
Lot : 5 0 5 0 5
22KHz 22KHz
Sat 99 /101 Sat 103 /110 /119
18V 13V 18V 13V FlexPort 1 FlexPort 2
Using the WB68 to replace SAM-6802 Narrowband 6x8 Multi-Switch
Multi-Switch IG-half.indb 5Multi-Switch IG-half.indb 5 9/6/05 1:34:51 PM9/6/05 1:34:51 PM

6
RG-6 cable run, max. 100 ft total
B-Band Converter Module (BBC Module, SUP-2400),
connect to the back of receiver.
B-Band Converter Module (BBC Module, SUP-2400),
connect to the back of receiver.
MPEG4-capable HD receiver
MPEG4-capable HD receiver
(Dish not shown. Appearance of LNB may vary depending on brand.)
110°/119° W.L. Ku LNBs
Ka/Ku LNB (99°/101°/103° W.L. LNB)
Non-MPEG4-capable Receiver
Non-MPEG4-capable Receiver (Local Channels are 2-digit numbers.)
(Local Channels are 3-digit numbers.)
Connecting with no WB68 (Possible Existing Connection)
If you have an existing Ka/Ku Dish system for HD receivers, but are not presently using a WB68, this diagram shows
what you are likely to have installed currently. Refer to the diagram on page 4 to see how your setup may have to
change.
©2005 DIRECTV, Inc.
DIRECTV and the
Cyclone Design logo
are registered
trademarks of
DIRECTV, Inc.
Due to restrictions
imposed by copyright
holders, certain
programming may
include content
protection measures
that may restrict
viewing in high
definition and/or
recording with certain
consumer electronics
equipment attached
to the receiver.
Please contact the
manufacturer of
such equipment for
additional information.
Rev. 1.0 —
WB68.050906
Multi-Switch IG-half.indb 6Multi-Switch IG-half.indb 6 9/6/05 1:34:53 PM9/6/05 1:34:53 PM