ZMODO CM-Z2213GY User manual

Parts Needed:
1 –5A power supply provided with camera
2 –18 gauge Siamese wire for the RS-485 control cable
Note: The blue wire on the camera is (+) and the red wire on the
camera is (-).
Most customers will use speaker wire for the RS-485 control wire.
3 –BNC video cable for camera
Installing the Camera:
1- Connect the power supply directly to the camera
2- Run the video BNC cable from the DVR to the PTZ camera
3- Run the 18 gauge Siamese cable from the DVR to the camera, and then connect the speaker wire on
both the camera and DVR/Joystick. {RS485 port A for (+) positive and B for (-) negative on DVR and

blue wire (+) positive and red wire (-) negative on PTZ camera}
Addressing the Camera:
In order to address the camera, you must use the dip switches provided on the unit.
The address range is 128-255
In order to begin addressing the camera, you must start with dip switch number 8 set to ON or in the up
position.
Dip Switch 1 2 3 4 5 6 7 8
Address Value 64 32 16 8 4 2 1 128
In order to confirm the addressing has been set, you must call preset 140 from the DVR/Joystick after
camera has been powered off and on.
*If you are only using ONE of the Z2213GY cameras on your current system, assigning an address to
the camera is not necessary. This camera will auto assign an address by turning all of the dip switches
to the OFF/down position.
Advanced Settings:
To configure any settings not described in the Quick Start Guide, please consult the included manual or
our knowledgebase page:
kb.zmodo.com
You will find instructions on how to set a cruise, tour, and an explanation of the built-in menu system
on the camera.

Lifetime Customer Support
Informative Knowledge Base at kb.zmodo.com
24/7 Live Support on www.zmodo.com
Mailing Address:
Champaign Office: 1401 Interstate Drive, Champaign, IL61822
LosAngeles Office: 17870 Castleton Street, Suite 200, Industry, CA91748