Zonet ZWA1207 User manual

T ABLE OF C ONTENTS
English………………………………………………………………………………1
Package Contents………………………………………………………………………1
Application……………………………………………………………………………………1
Hardware Installation…………………………………………………………………2
Wall Mount Installation…………………………………………………………………3
Trou leshooting……………………………………………………………………………5

1
Package Contents
 Two 7dBi Antennas
 One Antenna Base
 One Quick Installation Guide
 One Wall Mount Kit
System Requirements
 A 802.11n or 802.11 /g wireless router, access point or
wireless adapter with two detacha le antennas
 Two RP-SMA male antenna connectors
Application

2
Har ware Installation
ZWA1207 only work with 802.11n or 802.11 /g wireless routers, access
points or wireless adapters with two (2) antenna receptacles.
Wireless devices with only 1 or 3+ antennas will not work with ZWA1207.
Follow the steps elow to install ZWA1207 for your wireless device.
1. Screw 2 applied antennas to the
antenna ase.
ZWA1207 is now ready to use.
2. Remove 2 antennas from the
wireless device.
3. Attach ZWA1207 to the wireless
device y connecting 2 antenna
connectors at the end of the
ca le.
4. Power on your wireless device.

3
Wall Mount Installation
ZWA1207 can e mounted on the wall y using the holes on the ottom of
the mounting ase. When installing ZWA1207 on a wall, the mounting kit
must e first installed onto the wall.
1. Determine the optimal location
for ZWA1207 efore eginning.
2. Mark 2 holes 10cm apart from
each other y pencil and drill the
holes into the wall.
Note: Ensure you are using the
3mm (1.8 inch) drill bit size and
type for the wall.
3. Hammer the included anchors
into the wall until seated flush.
4. Drive the included screws into
the anchors until leaving
approx. 5mm screw exposed.
Leave Approx. 5mm

4
5. Mount ZWA1207 on to the wall.
6. For the est performance, adjust
the antennas to an optimal
position.

5
TroubleShooting
Trou leShooting provides solutions to pro lems that may occur
during the installation and operation of ZWA1207. Read the
descriptions elow to solve your pro lems.
Q1. Why oes some of my wireless PCs receive strong
wireless signals, while other PCs receive weaker signals?
ZWA1207 is an Omni-Directional antenna and can only send and
receive signals from a specified radius. Please adjust the position of
the wireless router or access point, extend ZWA1207 closer to an
optimal location or move those wireless PCs closer to the wireless
router or access point.
Q2. I can’t connect ZWA1207 to my wireless evice, what can
I o?
The wireless device’s connector type must e RP-SMA male.
Q3. Does ZWA1207 work with IEEE802.11a wireless router,
access point or wireless a apter?
No, ZWA1207 only compati le with IEEE802.11 /g/n wireless devices
with 2 antennas.
Q4. Can I connect two wireless evices to ZWA1207 at the
same time?
No, ZWA1207 only designed to connect one wireless device at a time.