ZUM Radio ZUMspot User manual

Mini 1.3 OLED ZUMspot kit user guide
Copyright 2019-2022 ZUM Radio, Inc 1 Rev 1.0
Mini 1.3 OLED ZUMspot
The Mini 1.3 OLED ZUMspot kit is a low power simplex digital mode hotspot. It supports DStar, DMR,
Fusion, NXDN, P25 and POCSAG.

Mini 1.3 OLED ZUMspot kit user guide
Copyright 2019-2022 ZUM Radio, Inc 2 Rev 1.0
Table of Contents
ZUMspot board specifications:.....................................................................................................................3
Kit includes:...................................................................................................................................................3
Setup:............................................................................................................................................................4
Powering up:.........................................................................................................................................4
Wi-Fi:.....................................................................................................................................................5
Configure display type: .........................................................................................................................9
Configuration: .....................................................................................................................................10
Configuration (example to enable D-Star):.........................................................................................11
Finished:......................................................................................................................................................12
Support: ......................................................................................................................................................12

Mini 1.3 OLED ZUMspot kit user guide
Copyright 2019-2022 ZUM Radio, Inc 3 Rev 1.0
ZUMspot board specifications:
ZUMspot board fully assembled and tested
High performance 32-bit ARM processor
Supports DMR, P-25, D-Star, System Fusion, NXDN and POCSAG
Onboard LEDs to show status (Tx, Rx, PTT, Mode)
Up to 10mW RF power
SMA antenna connector, UHF antenna included
The firmware is pre-loaded and is easily upgraded via software
Kit includes:
ZUMspot RPi UHF Board
Raspberry Pi Zero WH board
Custom case
3A power supply
1.3" OLED screen
UHF Antenna
Pre-Imaged 16 GB MicroSD Card with Pi-Star Software
1 Year Warranty

Mini 1.3 OLED ZUMspot kit user guide
Copyright 2019-2022 ZUM Radio, Inc 4 Rev 1.0
Setup:
●Make sure the SD card is installed in the Raspberry Pi Zero WH board
●Install the antenna onto the RF connector
Powering up:
●Plug in the USB micro power cable to the right-hand USB connector on your Mini 1.3 OLED
ZUMspot kit. Then plug the cable into the 5V/3A wall adapter and insert that into an AC outlet.
●If the Mini 1.3 OLED ZUMspot kit doesn’t power up, then press the switch on the cable and it
should power up now.

Mini 1.3 OLED ZUMspot kit user guide
Copyright 2019-2022 ZUM Radio, Inc 5 Rev 1.0
Setup Pi-Star:
Wi-Fi:
●Power up the Mini 1.3 OLED ZUMspot kit.
●After 3 minutes, scan for Wi-Fi access points from your phone or laptop. One should appear with
the name “Pi-Star-Setup”
●Connect to it. When asked for the Wi-Fi password type in: raspberry
●After 3 minutes, go to your web browser (Chrome, Firefox, etc.) and connect to the Pi-Star page:
http://pi-star (for Windows, Linux and Android devices
http://pi-star.local (for OS X and iOS devices)
●You should see this page. If not click on “Configuration”at the top.
●Go to Configuration
○You will be asked to enter the username which is “pi-star” and the password which is
“raspberry”