ZWO Asiair Operating instructions

ZWO ASIAIR FAQ
How to use ASIAIR with Sky-Watcher
AZ-GTI Mount
1 Preparations
Equipment
Manufacturer
Hardware
Software
ASIAIR
ZWO
ASIAIR
ASIAIR
AZ-GTi Mount
Sky-Watcher
Mount
SynScan Pro
With the use of the above equipment will achieve through the App,
please go to Google Play or App Store to download and install.
In addition to the equipment listed above, a telescope, camera,
tripod, power supply, etc. are required to fully assemble and start
shooting. This guide does not cover the work of these devices, you
can refer to their instruction documents.
二、Detailed Settings
* By default, you have assembled the hardware part of the device.
2.1 Switch ASIAIR WiFi Band
ASIAIR uses 5G band WiFi by default, while AZ-GTi Mount uses
2.4G, so you need to switch the ASIAIR WiFi band to 2.4G. Open the
ASIAIR App,
Press to switch to 2.4G.
ASIAIR WiFi SSID is ASIAIR_Dev.Fei which will be used later.
2.2 AZ-GTi Mount WiFi Settings
Connect your mobile devices to AZ-GTi Mount’s WiFi, the SSID is
SynScan , you needn’t to input password because it’s an open
network.
After connecting (e.g. with iPhoneX iOS 12.0.1 ):

ZWO ASIAIR FAQ
Open SynScan Pro, click Connect button on the top, then go to
Settings > Wi-Fi Setting, check Modify Station. Typical settings：
Station Mode, On；
SSID, your ASIAIR WiFi SSID, here is ASIAIR_Dev.Fei ；
Password, ASIAIR WiFi password 12345678；
Use DHCP, Off；
Fixed IP, The ASIAIR network segment is 10.0.0.*, here are free
to fill in rang 2 to 254. We’ve chosen a nice address: 10.0.0.10 .
Press Apply on the top right, waiting for completion. Then refresh to
check the result. If successful,

ZWO ASIAIR FAQ
2.3 Connect ASIAIR to AZ-GTi Mount
Now the AZ-GTi WiFi is working under Station Mode and connected
to ASIAIR WiFi. Let’s do the connection between ASIAIR and Mount.
Open ASIAIR App, go to Telescope Settings interface,
Telescope, Choose EQMod Mount, then：
Connect Method, Press to choose Ethernet，
IP: 10.0.0.10 (the Fixed IP set in 2.2),
Port: 11880 (AZ_GTi Mount default port),
Protocol:Press to choose UDP.
As below,
After setting, press to connect.