1 BY ONE OUS00-0189 User manual

Paper Thin Digital Indoor HDTV Antenna
Model OUS00-0189
Congratulations!You have just purchased the nest, technologically advanced,
easy-to-install, HD digital antenna for indoor use. 1byone® products have been
rated“best sellers.”We hope your investment in this quality antenna will give you
and your family years of enjoyment. Thank you for your purchase and your
support. We invite you to visit our website at www.1byone.com for other
high-quality products.
Package Contents -
Antenna with attached 10ft. coaxial cable
3M Adhesive Mounting Stickers
Instruction Manual
Warranty Card
www.1byone.com
Copyright ©2015 1byone Products, Inc. All rights reserved
Will the picture be better than cable?
All cable companies compress their HD signals. The result is a degraded signal that is usually inferior to
ATSC broadcast. Many factors determine whether your picture quality will be better in every instance.
However, your picture quality should greatly improve using your 1byone® ATSC compatible digital antenna.
Can I connect the antenna to multiple televisions?
No. However, the signal should only be split between multiple HDTVs if using an amplied antenna.
Troubleshooting
What if I can’t receive a signal with my 1byone® antenna?
1. Check to make sure you have correctly connected the antenna to your HDTV or third-party HD receiver.
See the Setup Guide under,“Connect the Antenna and Amplier”in this manual.
2. Re-Scan for Channels. See the Setup Guide under, “Scan for Channels”in this manual.
3. Reposition the antenna in a dierent location. Maybe higher on a wall or close to a window?
Facing the direction of the broadcast tower is usually best. Signal strength will vary based
on certain conditions. Distance from the tower, hills, buildings and even tall trees can impact
reception. Always re-scan for channels after moving the antenna.
One channel is missing.
1. Something may be obstructing the signal. Move the antenna, then re-scan for channels.
2. Try turning the antenna 10 or 20 degrees in either direction to avoid reection, then re-scan for channels.
The picture or sound freezes while I am watching a channel, or there are boxes in the picture.
This is often caused by a weak or intermittent signal. Try moving the antenna to a dierent location or
aiming it in the direction of the broadcast tower for that channel.
For Optimal Performance
Place your 1byone® antenna in the location with the strongest reception. Typically this will be on a
window and facing the broadcaster’s tower. A television signal can become weak or intermittent by trying
to pass through walls that are exceptionally thick or contain large amounts of metal. Your 1byone®
antenna can usually pick up the stronger signals from almost any direction. Experiment with dierent
walls and even dierent rooms to nd the best location to mount your antenna.To check the exact
distance from your residence to the nearest tower, go to - http://dtv.gov/maps and type in your zip
code.You will then have a better idea of what you should expect in the way of reception. If there are
multiple tower locations, optimize the position of your 1byone antenna by pointing it in the direction of
the weakest signal (usually the farthest away from you).
Distributed by
1byone® Products, Inc.
2313 E Philadelphia St, Ontario, CA 91761
www.1byone.com
®
25 mile maximum range possible. Individual experiences may vary.
尺寸：237X216mm 材质：铜板纸120g
正面背面
形式：折页

2. Mount Antenna
Find a convenient indoor location to mount your antenna then, set up the channels in the following,
“Scan For Channels”step below.
Note: Test your antenna location after scanning for channels & before nal mounting with the 3M
mounting stickers. In some instances, you may decide to relocate the antenna for better reception.
See“Antenna Placement Options and Tips”below.
If you do not want to mount the antenna to the wall or to a window, you can use the 1byone®
accessory antenna stand Model #O0000-0366 for convenient desk or tabletop placement.
Note: Antenna stand is sold separately. www.1byone.com
3. Scan for Channels
A. In the TV’s setup menu, set the mode to Antenna or Air. Refer to the TV manual for detailed
instructions.
B. While in the TV’s setup menu, set TV to scan for channels.This can sometimes be listed as
auto-program, channel search or channel scan. Consult yourTV manual for detailed instructions.
Antenna Placement Options and Tips
TV reception and quality depends on the distance from the transmitting tower to your home.
Surrounding environments may also aect signal strength and reception.
If your reception is sporadic or needs to be improved, try the helpful tips below,
1. Placing the antenna in a higher location may result in better reception.
2. Placing the antenna facing the broadcast tower may result in better reception.
3. Placing the antenna close to or on a window may also result in better reception.
Important:
Always re-scan for channels whenever you move your antenna.
Frequently Asked Questions
How many channels can I receive?
The number of channels you can receive will be determined by what is being broadcast in your area.
Channel reception will vary from location to location based on terrain (including trees, buildings,
hills and mountains). The fewer obstructions, the better your chance of receiving strong digital
signals. Go to http://dtv.gov/maps. Enter your address for a listing of likely channels available in
your area.
Do I need to use an External Amplier?
The amplier can enhance signals weakened by obstructions between you and the broadcast towers.
If your TV picture is not crystal clear, or you are unable get strong signals from distant towers, you
can use the amplier to boost the weakened signals.
Note: We do NOT recommend using the amplier if your house is very close to the broadcast tower
and the signal is already very strong. A booster will cause self-oscillation and you may actually end
up getting fewer signals than without it.
Will all the channels I receive be High Denition (HD)?
Not all digital signals are High Denition (HD). Make sure you are using a High Denition Television
(HDTV) with built in ATSC tuner. When connecting the antenna to a third-party receiver, make sure it
is capable of receiving HD. Otherwise no HD channels can be picked up.
里面
Connect the 10ft. coaxial cable to the ANT/IN or CABLE IN port on the back of your
TV. Note: For TV’s that require a tuner box, connect the coaxial cable to the tuner box
ANT/IN or CABLE IN port.
See the “Final Conguration” Illustrations below for
both connection options-
Back of TV
From 10ft.
Coaxial Cable
ANT/IN
CABLE IN
ANT/IN
When connected to HDTV with built in digital tuner
Digital
Antenna
HDTV
When connected to TV through digital tuner converter box
Digital Converter Box
Digital
Antenna
Traditional TV
1. Connect the Antenna on the back of Your TV
1
2