23zero OSPREY 270 User manual

TM
OSPREY 270
USER MANUAL

Thank you for purchasing a 23ZERO Osprey 270 awning
1
CONTENTS
Set Up
Attaching awning to brackets 2
3, 4 ,5
Pack down 6
Care and Safety 8
Optional Wall kits 7
Thank you for purchasing a 23Zero Osprey 270 awning. Please read these instructions carefully
before installing the awning to your vehicle. Check all parts are included prior to rst use.
OSPREY 270 CONTENTS
1 x Osprey 270 awning
2 x Mounting brackets
4 x ‘U’ Bolts with nuts & washers
4 x 25mm M8 mounting bolts & nuts
Pegs & guy ropes in bag
1 x Cam buckle tension strap
Osprey 270 mounting brackets are suited to many roof rack designs, however, with the
increasing number of new designs / models available from reputable brands, some additional
hardware may need to be obtained for correct secure tment.
MOUNTING BRACKETS TO ROOF RACK
Note: We highly recommend discussing specic load capacities and mounting options with a
specic roof rack retailer or installer.
Prolonged traveling on uneven tracks and/or corrugated roads will require more
frequent inspections. 23ZERO takes no responsibility or liability for tment of the
Osprey 270 awning to your specic vehicle or trailer
23ZERO recommends using a qualied or experienced tter to mount the Osprey 270 to your
vehicle. Fasteners and all xing connections including hinges bolts should be checked and
inspected regularly to ensure the awning is xed securely to your vehicle roof rack at all times.
TM
OSPREY 270 USER MANUAL
Warranty 9

2
TM
OSPREY 270 USER MANUAL
Attaching brackets to awning
1. Place the awning on a protected clean surface with rear facing up.
2. At each end of the awning measure and mark the PVC in line with the two channel
grooves at approx 500mm back from end of awning (ideally no more than 600mm) See
Fig. 1 & 2
Fig. 1 Fig. 2 Fig. 3
3. Using a sharp blade, score a 5mm cross at the centre of the channel groove at your
measurement marking. See Fig.3
Note: The position of the channel grooves can be felt by pressing down and running your
nger along the PVC.
4. Totally un-zip awning cover.
5. Start at one end carefully pull back each side of the PVC so channel grooves are
exposed. See Fig.4
Fig. 4 Fig. 5 Fig. 6 Fig. 7
6. Insert two 25mm M8 bolts in each channel groove and slide across in line with your
marked score in the PVC. See Fig. 5
7. Place scored PVC directly above the bolt and push down rmly until the bolt pierces
PVC and is exposed. See Fig. 6
8. Align bracket holes with bolts and fasten using M8 nut and washer. See Fig. 7
9. Repeat for all three bracket
2
1

3
Set up
Note: The Osprey 270 will free stand for set-up and pack down
TM
OSPREY 270 USER MANUAL
REMOVE COVER
Unzip cover (1.) and fold over awning body (2.)
1.
DEPLOY AWNING
Release the 3 retaining straps (1.) and allow canvas to drape (2.)
1.
4
3
2.
2.

4
TM
OSPREY 270 USER MANUAL
Fully swing out outer arm toward rear of vehicle (1.) Attach cam buckle strap to roof rack
and then to awning (2.) Tension strap to keep awning taut.
Set up
5
1.
2.

5
TM
OSPREY 270 USER MANUAL
Set up
POLE SET UP
1. Undo Hook and Loop tabs supporting integrated leg poles.
2. Adjust leg pole height accordingly with twist lock function.
Repeat for all leg poles.
3. Attach guy ropes to webbing loops above all leg poles and anchor securely.
IMPORTANT: Hook and loop tabs must be attached around rafters at rst use.
Ensure these are always re-attached once leg poles have been deployed and
and awning is in use.
Guy ropes must be attached and anchored at all times
TIP
In case of rain lower the support leg poles
to allow downward slope. Guy off between
rafters to form valleys for water run-off.
6
1a. 1b.
3.
2.

6
Pack Down
TM
OSPREY 270 USER MANUAL
1. Remove pegs and guy ropes. Fold away legs and secure with hook and loop tabs.
2. Release cam buckle strap and unhook from awning and roof rack.
3. Swing rear of awning around against awning body (side of car)
4. Adjust hanging canvas so it drapes in a triangular shape.
5. Tightly roll canvas and secure with attached straps.
6. Fold over PVC transit cover and zip up.
7
3a. 3b.
4. 5a.
5b.

7
Optional wall kits
TM
OSPREY 270 USER MANUAL
8
The Osprey wall panels are all the same size and will attach to any side of the awning. A
total of 4 wall panels will fully enclose the awning (areas against vehicle excepted).
Walls are attached to the awning via zip and walls are attached together via hook and loop
closure.
NOTE - JOINING ZIPS: Ensure the zip insert pin is fully
engaged / seated into the zip retaining box. Commence
zipping whilst holding up the wall at awning level with
your opposite hand.
It is imperative to hold the wall up at awning level whilst zipping to relieve pressure
on zip track. Failure to do this will result in zip damage and will not be covered
under warranty.
Anchor walls to ground with pegs through shock cord loops.

8
Care and Safety
TM
OSPREY 270 USER MANUAL
CLEANING
Clean with luke warm water and soft bristle brush.
Do not use soaps and or detergents.
Do not expose to petro chemicals.
STORAGE
Certain situations may require the OSPREY 270°
to be packed down wet. It is essential that at the
earliest opportunity the Osprey awning is unpacked
and allowed to dry fully. Though we use the
best polyurethane proong available, prolonged
exposure to moisture causes hydrolysis which can
affect the integrity of the proong.
Storing awning wet in warm conditions is likely to
cause mildew growth which will stain canvas and
lead to premature breakdown.
WATERPROOFNESS
23 ZERO use a selection of rened raw materials
and treatments in its design and development
processes including long lasting polyurethane
coatings and high frequency seam sealing.
With multiple layer seams and addition of zips,
wind driven rain may cause small amounts of water
ingress at times. Rubbing a softened candle wax
stick over the affected area will help reduce any
water ingress.
STRUCTURAL
The FALCON 270° has been designed for general
use under normal conditions.
Always ensure legs, guy ropes and pegs are
attached and the awning is rmly anchored at all
times regardless how good conditions may be.
RECOMMENDS THE OSPREY 270° SHOULD
NOT BE ERECTED DURING WINDY AND OR
ADVERSE WEATHER. DAMAGE CAUSED
BY WEATHER OR IMPROPER USE IS NOT
COVERED UNDER WARRANTY.
TO AVOID PERSONAL INJURY AND
OR PROPERTY DAMAGE, 23ZERO

9
2 Year Warranty
23ZERO will replace or repair any product at its discretion that is subject to faulty manufacturing
or workmanship including materials.
Exclusions
The above warranty is limited to manufacturing and materials defects. Not including damage
caused by misuse or abuse, wear and tear, condensation, extreme weather, accidents, incorrect
set up, damage caused by mould, insects, animals or children. This also excludes broken poles
and damage caused by a jammed, snagged zipper or excessive force applied to zipper causing
failure.
Consumer rights
Our goods come with guarantees that cannot be excluded under Australian law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have goods repaired or replaced if the
goods fail to be of acceptable quality and failure does not amount to a major failure.
* Due to our policy of continual product development, the specications, colours and features
may vary.
Making a claim
To make a claim in relation to the above manufacturers warranty please ensure you retain your
sales receipt of purchase. Please email us at [email protected] stating the nature of
your claim and we will be in touch with you shortly. If you require additional assistance, please
phone [phone] to discuss and arrange your claim. Product subject to warranty will be sent
to 23ZERO Australia, 32b Eileen Rd. Clayton South, Victoria 3169. All freight costs associated
with return of product for assessment is payable by consumer.
TM
OSPREY 270 USER MANUAL