ASSEMBLY INSTRUCTIONS
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS :1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
MODEL : VITARA COFFRE 5' BED PART LIST
ITEM DESCRIPTION QTY
AHEADBOARD 1 PC
BFOOTBOARD 1 PC
CSIDE RAIL 2 PCS
DBOTTOM SUPPORT BOARD 4 PCS
EBED LEG 4 PCS
FHANDLE 2 PCS
GBOTTOM SUPPORT LEG 20 PCS
HMETAL FRAME 1 SET
IBED SLAT 26 PCS
JPP TAPE 1 PC
KGAS SPRING 2 PCS
LMETAL SUPPORT LEG 1 PC
M2 SMALL ANGLE 2 PCS
PAGE 1 OF 2
11
7C
B
A
1
11
C
STEP 4 STEP 5
PART LIST
ITEM DESCRIPTION QTY
1JCBB BOLT M8 x 40mm 12 PCS
2M6 HEX NUT 6 PCS
3BED SLAT SIDE FITTER 26 PCS
4BED SLAT CENTER FITTER 13 PCS
5JCBC BOLT M6 x 30mm 28 PCS
6JCBB BOLT M8 x 20mm 4 PCS
7JCBB BOLT M8 x 30mm 8 PCS
8BLOOSOM HANDLE 2 PCS
9JCBC BOLT M6 x 40mm 6 PCS
10 M4 ALLEN KEY 1 PC
11 M5 ALLEN KEY 1 PC
12 SPANNER (10mm) 1 PC
13 JCBB BOLT M8 x 70mm 8 PCS
14 M8 FLAT WASHER 16 PCS
15 M8 SPRING WASHER 16 PCS
16 M8 HEX NUT 16 PCS
17 SPANNER (13mm) 1 PC
18 SPECIAL HEX NUT 6 PCS
19 HANDLE SCREW M8 x 60mm 2 PCS
20 M6 FLAT WASHER 12 PCS
21 M6 SPRING WASHER 4 PCS
5
A
E
20 10
B
10
5
D
G
16
15
14
13
11
H21 2
20
12
910
M
16
17
15 14 F
16
15 J
14
1
11
STEP 1 STEP 2 STEP 3