30-Day Duro 20-PL20C3D User manual

30-Day Duro LED Lantern - Owner’s Guide
General Operating Instructions
HIGH, MEDIUM & LOW MODES: Install batteries (see instructions on reverse
side). Press power button once for HIGH MODE, twice for MEDIUM MODE, 3
times for LOW MODE and 4 times for OFF.
FLASHING SOS: Press and hold power button for a few seconds until SOS
ash begins. This can be done in any mode. Press power button once to reset
(this will turn the lantern o).
TO CONVERT TO A DOWNLIGHT: Unscrew lens and place aside. Unlatch hook
underneath the lantern. Turn the lantern upside down and hang securely.
Ultimate Survival Technologies
Jacksonville, FL 32256
[phone]
www.ultimatesurvival.com
The power button changes
lighting modes as well as
powering the lantern on and o
Modular hook under
the lantern unsnaps
and ips forward
Bottom View
Lens unscrews by turning counter-clockwise

Align red arrows. Match notch
on unit body to the groove on
the base cover, as shown. Fold
cover down, push in and then
turn clockwise to close.


Groove on lid
Notch
Battery Changing Instructions
Switch o lantern. Turn base counter clockwise (unscrew) to remove old
batteries and properly dispose. Replace with 3 new 1.5V D cell batteries in
correct polarity following + and - symbols in the battery compartment.
Line-up arrows and notches inside unit, then push down while screwing
the base to the body (see diagram). Make sure that the base is tight in
order ensure water resistance. Remove batteries when not in use for a
long period of time. Do not mix old and new batteries -- or rechargeable,
standard and alkaline types.
FRONT VIEW 100%
BOTTOM VIEW 100%
WARNING:
Do not look directly into
the LED light for more than
a few seconds.
Do NOT allow children to
use LED light unless under
the supervision of an adult.
Remove the batteries if not
using the LED light for over
30 days or before storage.
Turn base counter-
clockwise to remove