360 Hunting Blinds Metal Tower Stand Manual

Metal Tower
Stand Setup
Instructions

Safety
At no time shall 360 Hunting Blinds be liable for any accidents due to falls from the hunting blind. We recommend that you follow
standard safety procedures when entering and exiting the blind, such as the use of safety harnesses, climbing ropes, etc.

2
This is the wrong way to attach the brack-
et.
This is the correct way to attach the brack-
et.
Arrange parts so you can make sure you have all
the pieces and can find them easily as you build.
Attach top base brackets as shown.
1

5
6
7
8
Repeat for all four legs.
Find the two legs with a set of holes
drilled close to the top.
Position them as shown.
Attach the platform mounting bracket as
shown.
Repeat for the second leg as shown.

10
11
12
Attach the ladder handrail to the platform as shown.
Attach ladder sections as shown.
Attach the base feet to the bottom of each leg as
shown.
Note: be sure to use the feet that have holes for
anchor stakes.
If you purchased a 4’ extention, attach the feet to
the extention section instead.
Repeat for each leg.
9

13
14
15
16
Fasten the steps to the ladder handrail
sections as shown.
Attach feet to bottom of ladder as shown.
Be sure to use the feet that do not have
anchor stake holes.
If you purchased a 4’ extension, put the
feet on the extention instead.
Find the two legs that are setup for the ladder
bracket and position them like this on each side of
the widest side of your 360 tower floor.
This layout is incorrect.

18
19
20
Slide the ladder attachment pipe through the
ladder mounting brackets on the tower stand legs
as shown.
use the included hardware to keep the ladder
attachment pipe from sliding out of the brackets.
Use one, 4” bolt.
Securely fasten the legs to the tower floor.
Use sixteen, 2” lags (4 per leg).
Use the included hardware to attach the braces
between each of the legs as shown.
Use eight, ¾” bolts.
17

24
21
22
23
Hook each included cable brace onto the tabs as
shown here.
Gently tip the assembled tower stand onto it’s side.
Flip the tower stand upright and adjust it on it’s
future site as needed.
Place a level on the braces between each of the
legs to determine if the stand needs to be leveled.
Wooden shims, or rocks can be used to build up
the low sides. Alternately you can use a shovel to
dig away soil under the stand foot that needs to be
lowered.

24
21
22
23
Move the ladder into postion on the stand so it fits
snugly into place against the ladder attachment
pipe. The included u-bolts should be used to fasten
the ladder platform to the ladder attachment pipe
on the tower stand.
Use two U bolts and four flat washers.
Grab the adjustable hook end of each cable brace
and hook it into the hole designed for it on the
oposite corner.
When finished the cable braces should create an X
on each side of the tower stand.
Tighten each of the adjustable hooks on the cable
braces equally with a sturdy tool until cables are
snug. Be careful not to over-tighten.
Use a heavy sledge hammer to secure the
tower stand in place with the included stakes which
should be driven through the holes provided in
each towner stand foot.

24
21
22
23
Finished product.
Refer to your 360 Hunting Blind Assembly manual
to setup your wall panels before proceeding to the
next step.
Attach the hand rails to the ladder platform.
Use the included hardware to securely fasten each
of the handrails to the ladder platform as shown.
Use four, 1 ¾” bolts.