3branch Discovery User manual

3branch.com3branch.com ©3branch All Rights Reserved.©3branch All Rights Reserved. 877.899.9902877.899.9902
Terms & Conditions
Returns
Returns are not accepted without prior authorization. The customer
is responsible for return freight costs. Returns will be credited when
received goods have been inspected. Returns must be in new condition
and must be shipped in their original cartons with packing materials.
Please call 847.291.3900 for authorization.
Cancellation
A full refund will be given if the order is cancelled within 48 hours of
ordering. Cancelled orders after 48 hours from order date and prior to
shipment result in a 30% restocking fee.
Warranty
Our products carry a 30 day warranty from product defect. Warranty
is void if damage is caused by misuse, misapplication, or if the product
is modified. We reserve the right to repair, refund or replace an item.
Liability
Under no circumstances, shall 3branch or its affiliates, employees,
directors, officers, vendors or suppliers be liable for any direct or
indirect losses, damages or injuries arising out of or in connection
with the use or misuse of our products.
start here!
discoverytm activity table system
assembly instructions & hardware
Thank you for purchasing the DiscoveryTM activity table
system. These instructions will show you how to properly
assemble your product. Please read instructions and follow
them thoroughly and carefully.
For questions, please call 877.899.9902
For questions or comments, please call 877.899.9902

3branch.com ©3branch All Rights Reserved. 877.899.9902
discoveryTM activity table system
assembly instructions
discoveryTM hardware & tool items
n1 nut
b1 bolt
m4
allen key
drawer key ⅝flat
wrench
check your packing list & unpack
1. Packing list is attached to outside of box
Ensure you have all DiscoveryTM components.
2. Move all packages to intended area for set-up.
3. Unpack DiscoveryTM components. Place the
table in desired location.
prepare components for assembly
1. For all tables and benches, unlock drawer using a
drawer key supplied in hardware bag.
2. Slowly slide drawer open, ensuring the unit doesn’t tip.
3. Locate the holes on the sides of the unit.
insert n1 nut into tables & benches
1. Insert n1 nut in each open hole as shown in image 3.
Repeat this step as needed for all tables and benches.
2. Once all n1 nuts are inserted, you are ready to attach
additional components.
attach components with b1 bolts
1. With two people, hold components together so that
all holes align. While holding components in position,
insert b1 bolt and “start” each screw by hand.
2. Make sure all b1 bolts are snug before releasing
weight of attached component.
hand tighten bolts
1. Use the m4 allen key and turn clockwise to hand
tighten each bolt snug.
2. Repeat step 3 - 5 as needed to complete assembly
of all components. When complete, add table top
and cushions if applicable.
adjust table or bench levelers
1. Use ⅝flat wrench to adjust level of table or bench.
2. Insert wrench under table or bench at the feet.
3. Ensure wrench is seated properly. Turn clockwise to
lower foot; counter-clockwise to raise.
NOTICE: For end panel and tower components, n1 nuts come embedded
from the factory. Use b1 bolts accordingly to attach these components.
1
2
3
4
5
6
SAFETY WARNING
Do not attempt to assemble the table system alone.
Use two people when moving and or attaching components.
Components are heavy. Personal injury or product damage
can occur if precautions are not taken! Be smart, be safe.
Assembly of this product comes down to simple nuts and bolts. The
following directions will get you started. Whether assembling a single
table or a large configuration, these basic steps will provide everything
you need to assemble your product.