3idee de-sdc User manual

www.3idee.eu
de-sdc VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following Dell products (dell.com):
S2419HM, S2719DM, S2719DC.
With the VESA adapter, you can easily mount your DELL brand monitor to a
monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and
nuts.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
First, mount the stand of your Dell monitor. Remove the 2
screws at the bottom. (Figure 1)
Figure 1
Step 2
Now plug the 3idee VESA adapter onto the mount on the
monitor. (Figure 2)
Note: Please note the marking above / below!
Figure 2
Step 3
Now screw the 2 small, long screws into the VESA adapter
from below. (Figure 3)
Figure 3

3Assembly instructions
Step 4
Now you can hold the monitor with one hand and attach it to
your VESA arm with the other hand by tightening the 4
screws from behind. (Figure 4)
Figure 4
Step 5
Please check again if all screws are tightened properly.
(Figure 5)
Figure 5

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)