3idee VESA xia-1c User manual

www.3idee.eu
xia-1c VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following Xiaomi (mi.com) products:
Desktop Monitor 1C.
The VESA adapter allows you to conveniently mount your XIAOMI brand monitor to
a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and
nuts for this.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
Remove the base of your monitor if it is already attached.
Step 2
Mount the adapter to the VESA connector of your monitor
arm or directly to the wall. (Figure 1)
Figure 1
Step 3
Once you have completed the last step, please check if all
screws are tightened. (Figure 2)
Figure 2

3Assembly instructions
Step 4
Now insert the metal part of the monitor into the VESA
adapter with one hand and hold the VESA arm with the other
hand. (Figure 3) Please make sure that you secure the
monitor well with your hand while it is not fully
screwed.
Figure 3
Step 5
Now continue to hold the monitor in the VESA adapter with
one hand and secure the monitor with the supplied screws
with the other hand. The markings on the side (red) serve as
an orientation guide for the position of the holes under the
VESA adapter. (Figure 4)
Figure 4

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)