A4Tech G9-660 User manual

User Manual
Model: G9-660
www.a4tech.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to
radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
●Reorient of relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply without testing of
specific absorption ratio (SAR).

Hardware Installation
Plug receiver into USB port of your computer or notebook.
Insert the supplied battery, make sure that the positive (+) and negative (-) ends
of the battery match the polarity indicators inside the battery housing.
Power Management of the Mouse
1. To power on the mouse, switch the power button to “ON” position, or press
power button about 3 seconds.
2. To turn off the mouse power, switch the power button to “OFF“ position, or
press power button.
Note: The mouse can be activated from sleeping mode easily by moving it around.
The wireless mouse is plug-and-play. No driver is required. If you would like to get more function, please download software in our
website: www.a4tech.com.
Specification
RF Data Transmit Rate 500k bps Frequency 2.407GHz ～2.473GHz
Modulation Type GFSK ID Codes 524,288 sets

Software Installation
1. Before installing the mouse software, please uninstall any previously installed
mouse software.
2. Extract the ZIP file to your local disk and double click to start installation.
3. Follow on-screen instructions to complete the installation.
4. The icon will appear on your desktop, then you have successfully installed
the software.
5. To launch the software, double click the icon on your desktop or go to
Start—Programs—8 in Right, then the icon will appear in the taskbar at the right
corner of your screen.