Aalberts Flamco Flamconnect GW-10 User manual

Flamconnect
GW-10
ENG
Installation and Operating instructions
flamcogroup.com/manuals
Mount the antenna on the ‘cell‘ connection
Fix the gateway near the device. Make sure the antenna is
not surrounded by lots of metal parts or casing as this might
interrupt the cellulair signal.
LogoTronic controller (SG0004)
Connect RS485 cable to the LogoTronic controller. Make sure
the RS485 communication setting is on ‘HFC protocol‘.
Connect communication cable to the gateway
If supplied put th powerplug into the socket.
Flextronic controller (S90002)
Connect RS485 cable to the le RS485 port of Flextronic
controller. In the right RS485 a resistor needs to be placed.
Make sure the RS485 communication setting is on ‘Gateway‘.
SPC controller (S90000)
Connect the bushing plug onto the controller. The power
supply on the serial must be enabled via the device menu.
Registration gateway
Register the gateway on the Flamconnect portal. Please use
www.flamcogroup.com/register-gateway or scan the
QR-code. Or fill in the serial number in the portal and press on
‘register device‘. The gateway needs 5 minutes to set up the
connection.
Dekimo controller (S9001)
Connect the bushing plug onto the controller.
1.
3a.
3c.
4.
3d.
3b.
2.
4 3 2 1
KP905251

Flamconnect
GW-10
ENG
Installation and Operating instructions
User Led (4)
O Startup script not started yet
Red (solid) Startup script is running
Red (blinking) The gateway is up and running, there is no internet connection
Amber (blinking) The gateway is up and running, but no connection with Flamconnect Portal and no serial data from device
Amber (solid) The gateway is up and running, serial data from device is received but there is no connection with Flamconnect portal
Green (blinking) The gateway is up and running and connected with Flamconnect but there is no serial data from the device
Green (solid) The gateway functions as supposed and is connected with the device and the Flamconnect portal
All colours (blinking) Identification mode has been enabled from the Flamconnect Portal (duration: 30s)
Keep parts in their original packaging and unpack them only shorty before use.
Flamco is in no way liable for any damage due to improper transport and/or handling; does not accept any type of responsibility for damages to the device or to
devices connected to it, to people or property arising from improper use or the incorrect installation and put into operation of the product.
Our general terms and conditions apply to our products see flamcogroup.com/terms.
For more information on the product, please contact Flamco or visit www.flamcogroup.com.
flamcogroup.com/manuals
Safety requirements
4. 5.
Power Led (5)
O The gateway is not powered
Red The gateway is powered but there is no SIM installed, no antenna mounted or no cellular network signal
Orange The gateway is powered, SIM is installed, antenna is mounted and has cellular network signal